H.264 recording(SD memory card)[Pre alarm]Determine whether or not to perform the pre-alarm recording. When “Use” is selected, 1 MB image data isalways saved during the pre-alarm recording.Use/ Not use• Default: Not use[Post alarm (recording) duration]Set the duration to save image data on the SD memory card after an alarm occurrence.10s/ 20s/ 30s/ 40s/ 50s/ 60s/ 120s/ 180s/ 240s/ 300s• Default: 30s* The actual recording time may sometimes be longer than the duration selected for this setting.[Recording (memory) size per an alarm]The capacity of the SD memory card used to record video data upon an alarm occurrence. The actual capacitymay be different.IMPORTANT• To record H.264 data, it is required to select “Use” for “SD memory card” on the [SD memory card] tab.In addition, it is required to select “H.264” for “Recording format”. (®page 42)13.4 Configure the VMD settings [VMD area]Click the [VMD area] tab on the “Alarm” page. (®page 32, page 34)The video motion detection areas can be set on this page.Up to 4 areas can be set. When motion is detected in the set area, it will be regarded as an alarm.IMPORTANT• The alarm occurrence indication button (®page 9) will be displayed when motion is detected by theVMD function.• The alarm occurrence indication button will be displayed when receiving an alarm input of a commandalarm.• Depending on the network environment, notification may be delayed even when “Real time” is selectedfor “Alarm status update mode” on the [Basic] tab of the “Basic” page (®page 38).• The motion detection function is not the dedicated function to prevent thefts, fires, etc. We are notresponsible for any accidents or damages occurring in case.90 Operating Instructions13 Configure the alarm settings [Alarm]
