Panasonic WV-NP502E Installation Manual

Also see for WV-NP502: Product catalog Integration note Product catalog Comparison chart Operating instructions

Contents

Panasonic WV-NP502E Installation Manual Manual pdf 18 page image

18InstallationConnect the safety wireThe following is an example of safety wire connection. A safety wire kit shall be procured in accor-dance with the mounting face of the camera.Refer also to the instructions for the safety wire kit at mounting the safety wire.Important:• Be sure to install the safety wire. Ask your dealer for installation.For mounting on ceilingkit>• Camera mounting plate: WV-7010A• Safety wire kit: WV-Q141z Remove the tripod mount base on the top ofthe camera.x Align the tripod mount base with the safety wireplate for ceiling (accessory) and attach them tothe camera with the mounting screws.Important:• Use the detached mounting screws to attach the tripod mount base. When using differentlength screws, it may damage the camera or cause the camera to fall.(Recommended tightening torque: 0.39 N·m)c Engage the safety wires (2 pieces) with the wire engaging holes (front and rear) respectively.Wire engaging holeConnection hookSafety wireTMounting screwsExhaust portTripod mountbaseSafety wire platefor ceiling(accessory)Wire engaginghole (front)Wire engaginghole (rear)q Pass the ring part of the safety wirethrough the wire engaging hole.w Pass the connection hook through the ringpart of the safety wire.Important:• Use caution to prevent the safety wire from entering into the exhaust port.