Panasonic WV-NP502E Installation Manual

Also see for WV-NP502: Product catalog Integration note Product catalog Comparison chart Operating instructions

Contents

Panasonic WV-NP502E Installation Manual Manual pdf 17 page image

17Insert/remove an SDHC/SD memory cardImportant:• Before inserting a SDHC/SD memory card, turn off the power of the camera first.• Insert the SDHC/SD memory card backside up.• Before removing the SDHC/SD memory card, select "Not use" for "About SD memory card" onthe [SD memory card] tab of "Basic" on the setup menu first. Turn off the power after "Not use"selection, and then unload the SDHC/SD memory card. (☞ Operating Instructions)z Open the slide cover on the side of the camera, and then insert a SDHC/SD memory card intothe SDHC/SD memory card slot.x If necessary, loosen the screw of the clamp for SDHC/SD memory card and tighten the screwafter rotating the clamp 90° clockwise.(Recommended tightening torque: 0.19 N·m)c Close the slide cover on the side of the camera.v To remove the SDHC/SD memory card, rotate the clamp for SDHC/SD memory card 90degrees counterclockwise, push the memory card to unlock it, and remove the memory cardfrom the SDHC/SD memory card slot.ABFSDCARD LOCKABFSDCARD LOCKABFSDCARD LOCKTWTWTWLabel face downwardScrew of the clamp for SDHC/SD memory cardABFSDCARD LOCKABFSDCARD LOCKABFSDCARD LOCKTWTWTWLabel face downwardScrew of the clamp for SDHC/SD memory card