2. Unscrew the red screw fortransport protection with aPhillips screw driver.3. Connect the power cable and theBNC plug of the video outputcable as described in the section"CONNECTIONS".Loosen threescrews.Insulate the three connecting leads of the power cords from one another, and cover theconnecting portions with insulating tape as well as the portions between the video out-put cable and the BNC connector and between the BNC connectors to prevent the por-tions from water immersion. How to mount the camera1. Remove the dome cover from themain body by loosening the threedome cover mounting screws.The dome cover is fixed with tamperproofscrews.Loosen the three dome cover mountingscrews by using the supplied bit for tam-perproof screw.Shown figure is an example for junction box.Camera mounting screw x 4 (supplied)Seal the screws and screw holes with such a material as siliconeclay (rubber) to prevent water immersion if the camera is installedin the outdoor.46 mm(1-13/16")83.5 mm(3-5/16")4. Secure the camera with four camera mounting screws.• For WV-CW474FSecure the camera on the junction box with four camera mounting screws.The four camera mounting screws are not supplied. Please take note that you shouldpurchase the screws in accordance with the tapped holes of the junction box.The mounting holes of this unit accept M4 or less screws.Camera mounting screw x 4(procured locally)Loosen the domecover mountingscrew x3• The camera mounting bracket is not designed for waterproof.Insulate the three connecting leads of the power cords from one another, and cover theconnecting portions with insulating tape as well as the portions between the video out-put cable and the BNC connector and between the BNC connectors to prevent the por-tions from water immersion.• For WV-CW474SSecure the camera on the camera mounting bracket mounted on a wall or ceiling.Power cordVideo output cablePower cordVideo output cable