Panasonic WJ-ND200 Operating Instructions Manual

Also see for WJ-ND200K: Setup instructions Operating instructions

Contents

Panasonic WJ-ND200 Operating Instructions Manual Manual pdf 34 page image

34Supplies a signal from the ALARM connector or the ALARM/CONTROL connector on the rear panel of thisunit (Alarm signal output)It is possible to output signals from the ALARM connector or the ALARM/CONTROL connector on the rear panel ofthe unit and sound the buzzer when an event occurs. The alarm signal output duration can be configured on thesetup menu. (Refer to the setup instructions (PDF) for further information.)Records the event logThe event type and the occurrence time and date will be recorded when an event occurs.Transmits recorded images to an FTP server at an event occurrenceWhen an event occurs, recorded images will be continued transmitting to an FTP server automatically for the setduration from the recording start time. To send the alarm mail at an event occurrence, it is required to perform thesettings on the setup menu in advance. (Refer to the setup instructions (PDF) for further information.)Notifies of an alarm occurrence according to the Panasonic alarm protocol settingsSelect "ON" or "OFF" to determine whether or not to notify of an alarm occurrence (or error information) to a PCaccording to the "Panasonic Alarm Protocol" of the setup menu ("Comm" – "Panasonic Alarm Protocol").To receive a notification (or error information) and display the contents of the notification, the optional software (WV-AS65, ver. 3.0 or later) is necessary.