Panasonic Viera TX-P42S30B Operating Instructions Manual

Contents

Panasonic Viera TX-P42S30B Operating Instructions Manual Manual pdf 74 page image

Link Functions (Q-Link / VIERA Link)74Reduce unnecessary power consumption in standby [Standby Power Save]Set Standby Power Save [On] in the Setup Menu to use this function [Standby Power Save] (p. 34)The power consumption in Standby mode of the connected equipment is controlled in synchronizationwith the TV On / Off state.When the TV is set to Standby mode, the connected equipment is automatically set to Standby and thepower consumption in Standby mode of the connected equipment is automatically minimised.When the TV is turned on and the connected equipment is still in Standby mode, the powerconsumption of the connected equipment is increased to reduce the startup time.• This function is effective if the connected equipment can change the power consumption in Standbymode and is set to higher consumption.Auto standby for unnecessary equipment [Intelligent Auto Standby]Set Intelligent Auto Standby [On (With reminder)] or [On (No reminder)] in the Setup Menu to usethis function [Intelligent Auto Standby] (p. 34)When the TV is On, non-watched or non-used connected equipment goes into Standby modeautomatically to reduce power consumption. For example, when the input mode is switched from HDMI,the connected equipment will go into Standby mode / when Speaker Selection is changed to [TV], thePlayer theatre will go into Standby mode (except when watching a disc).• If you select [On (With reminder)], the on screen message will be displayed before the connectedequipment turns to Standby.• This function may not work properly depending on the connected equipment. If required, set to [Off].Direct TV Recording - What you see is What you record [Direct TV Rec]Recording the current programme on a DIGA Recorder immediately.• If you connect a variety of recorders including other manufacturers’ recorders at the same time, pleaseconnect the DIGA Recorder to the TV’s lower HDMI terminal number. For example, if you use HDMI1and HDMI2 for two recorders, connect the DIGA Recorder to HDMI1.• If Direct TV Recording does not operate, check the settings and the equipment“Summary of Q-Link and VIERA Link features” (p. 70, 71), “Preparations” (p. 73)• If you wish to record a programme that the DIGA Recorder does not support, a SCART connection isrequired and the programme is recorded by Q-Link function (p. 72).• Depending on the programme, a SCART connection may be required to record.• Changing channel or turning off the TV is available while the recorder is recording from its own tuner.• Changing channel is not available while the recorder is recording from the TV tuner.1 Display [VIERA Link Menu]2 Select [Direct TV Rec] and start recordingVIERA Link MenuPause Live TVDirect TV RecVIERA Link ControlSpeaker SelectionStartHome CinemaRecorderStartaccess / startselect• You can also start recording directly.DIRECT TV REC■ To stop recordingSelect [Stop] in [Direct TV Rec]VIERA Link MenuPause Live TVDirect TV RecVIERA Link ControlSpeaker SelectionStopHome CinemaRecorderStartaccess / stopselect• You can also stop recording directly.Unlock the tunerGUIDETuner LockedPress EXIT to unlock and stop recordingEXIT