Panasonic Viera TX-P42S30B Operating Instructions Manual

Contents

Panasonic Viera TX-P42S30B Operating Instructions Manual Manual pdf 13 page image

Auto Setup133 ■ [Wired]1. Select [Auto] Check network cable connection.Check acquired IP address.Check for devices using same IP address.Check gateway connection.Check server connection for VIERA Connect.Connection Test : succeededThe test issuccessful and theTV is connected tothe network.: failedCheck the settingsand connections,and then select[Retry].Acquire IP AddressAuto ManualaccessselectAutomatically setup is done and the test of thenetwork connection starts.• To set manually, select [Manual] and seteach item. For details (p. 65)2. Go to the next step 4(Press twice)■ [Wireless]Select the connection typeConnection TypePlease select network connection type.Search for access pointWPS(Push button)accessselect[Search for access point]Access points found automatically are listed.1. Select your desired access point123Access Point ASSIDAccess Point BAccess Point C11n(2.4GHz)11n(5GHz)11n(5GHz)Available Access PointsNo. Wireless type Encrypt Receptionaccessselect: Encrypted access point• To search access points again(yellow)• For the information of thehighlighted access point • To set manually (p. 68)(red)2. Access the encryption key input modeEncryption Key SettingConnection will be made with the following settings:-SSID : Access Point AAuthentication type : WPA-PSKEncryption type : TKIPPlease input the encryption key.Encryption key• If the selected access point is not encrypted,the confirmation screen will be displayed.It is recommended to select the encrypted access point.3. Enter the encryption key of the access pointA B C D E F G H I J K L M N O P Q R S TU V W X Y Z 0 1 2 3 4 5 6 7 8 9 ! : #a b c d e f g h i j k l m n o p q r s tu v w x y z ( ) + - . * _Access Point SettingsEncryption key• You can set characters by using numeric buttons.“Characters table for numeric buttons” (p. 85)Set characters StoreBACK/RETURNselectset4. Select [Yes]NoAccess Point SettingsEncryption key is set to:-XXXXXXXXSelect 'Yes' to confirm.Select 'No' to change.Yessetselect• To re-enter the encryption key, select [No].• If the connection has failed, check the encryption key,settings and positions of your access point. And then,follow the on screen instructions.Quick Start Guide