Panasonic Viera TX-L32X5B Operating Instructions Manual

Panasonic Viera TX-L32X5B Operating Instructions Manual Manual pdf 78 page image

FAQs | On screen messages78Problem ActionsOtherThe LCD panel movesslightly when it ispushed with a fingerClattered sound mightbe heard There is some flexibility around the panel to prevent damage to the panel. The panel might move slightly when it is pushed with a finger, and clattered soundmight be heard. This is not a malfunction.Overcurrent errormessage appears The connected USB device might cause this error. Remove the device and turn theTV off with Mains power On / Off switch, then turn it on again. Check foreign objects are not inside the USB port.An error messageappears Follow the message’s instructions. If the problem persists, contact your local Panasonic dealer or the authorisedService Centre.On screen messagesMessage Meaning / ActionAll tuning data will be erased [Shipping Condition] will erase all tuning data (p. 48)Are you sure ? Confirm correct operation.Are you sure you want todelete this timer ?Press OK to delete timer.Press RETURN to return. Confirm correct operation.Bad signal The signal is weak. Check the aerial is plugged in properly. It may benecessary to have an aerial installer check the signal and aerial alignment. Reset channels. (p. 38)Child Lock is active!Press OK to enter PIN. The selected channel is locked in Child Lock (p. 45). You must enter the PINnumber before the channel will be displayed.Feature not available. It is not possible to record from COMPONENT or HDMI. Connect the recorderto the TV using a fully wired SCART cable for recording from the TV tuner. Confirm Q-Link or VIERA Link settings (p. 60 - 63)Feature not available.Press OK to view how it works. The selected feature on VIERA TOOLS is not available. Press the OK buttonto view the demonstration to explain how to use it.Found new software version.Press OK to start update (maytake over 40 mins) or pressEXIT to ignore and you canupdate when TV is in standby There is a new software available.Invalid operation - Pleasecheck settings andconnections. Check the Q-Link or VIERA Link connection and setting (p. 60 - 63)Invalid system time. Pleaseexit ! Cannot get the time information and cannot edit Timer Programming screen.Check the connection of the RF cable.Invalid system time, TimerProgramming will not work.Please press TV button onremote control and check timedisplay on Banner Cannot get the time information. If there is no time displayed on theInformation banner, check the connection of the RF cable.Max. number of timers alreadyset ! The maximum number of timer programming events is 15.New channels found!Press OK to update channellist.Press EXIT to ignore. There may be new channels available. This message will appear each time a change is made by the broadcasters.This message can be deactivated by setting [New Channel Message] to Off in[DVB Tuning Menu].Selecting OK will perform [Update Channel List].