Panasonic Viera TC-L42D30L Operating Instructions Manual

Panasonic Viera TC-L42D30L Operating Instructions Manual Manual pdf 76 page image

Frequently Asked Questions76Problem ActionsHDMISound is unusual• Set the sound setting of the connected equipment to “2ch L.PCM”.• Check the [HDMI1 / 2 / 3 / 4 Input] setting in the Sound Menu.(p. 30)• If digital sound connection has a problem, select analogue soundconnection. (p. 69)Pictures from externalequipment are unusualwhen the equipment isconnected via HDMI• Check the HDMI cable is connected properly. (p. 61, 66 - 67)• Turn the TV and equipment Off, then turn them On again.• Check an input signal from the equipment. (p. 69)• Use equipment compliant with EIA/CEA-861/861D.NetworkCannot connect to thenetwork• Check the LAN cable or Wireless LAN Adaptor is connected properly.(p. 52)• Check the connections and settings. (p. 52 - 56)• Check the network equipment and network environment.• If the problem persists, consult your Internet Service Provider ortelecommunications company.Cannot select thefile during DLNAoperations• Is the media server prepared? (p. 51)• Check applicable data format. (p. 72 - 73)Cannot operateVIERA Connect • Check the connections and settings. (p. 52 - 56)• The server or connected line might be busy now.Digital TV• Due to the digital reception technologies involved, quality of the Digital TV signals may berelatively low in some cases, despite good reception of Analogue TV channels.Unable to receivesignals with ahigh-performanceaerial• Install an aerial individually for the TV and VCR (or use a splitter).(Individual aerial)(Individual aerial)Aerial InputTVVCRAerialInputterminalAerial Output SplitterAerial OutputInterference or frozen /disappearing image inDigital TV• Check [Signal Condition] (p. 36). If [Signal Quality] is displayed inred, check aerial. If problem persists, consult your local Panasonicdealer.• Turn the TV off with the Mains power On / Off switch, then turn it Onagain.OtherThe TV goes intoStandby mode• Auto power standby function is activated.• The TV enters Standby mode about 30 minutes after analoguebroadcasting ends.The remote controldoes not work or isintermittent• Are the batteries installed correctly? (p. 6)• Has the TV been switched On?• Point the remote control directly at the front of the TV (within about7 m and a 30 degree angle of the front of the TV).• Situate the TV away from sunshine or other sources of bright light notto shine on the TV’s remote control signal receiver.