Panasonic VL-SWD272 Quick Start Manual

Also see for VL-SWD272: Operating instructions Important information and quick guide Quick start guide

Panasonic VL-SWD272 Quick Start Manual Manual pdf 1 page image

Wireless Video Intercom SystemKey Features• Highly Expandable:Up to 6 additional monitors can be connected to the main monitor using a combination of 7-inch wired monitors and 2.2-inch wireless monitors (However, themaximum possible number of 7-inch wired monitors is 3). In addition, PBX connectivity is also supported.• Wireless Monitor: Using the wireless monitor, check visitors and respond promptly from the living room, kitchen and elsewhere in the home even while youare doing something else. Up to 6 wireless monitors connectable. Max wireless range is 100 m with no obstacles. You can add on repeaters to expand the range.Up to 2 DECT repeaters connectable.• 7-inch Screen: The main monitor and extension monitor have a 7-inch wide screen that offers easy viewing of wide vertical and horizontal views.• Voice Change Function: This function makes woman’s voice (higher keys) sounds like a man’s (lower keys).• Electric Lock Release Support for Gate:The gate or door lock can be easily and quickly released using monitors (wired or wireless) from anywhere in the house.• Picture Recording Function: The main monitor and extension monitor can record doorphone images from up to 50 doorphone calls or monitoringsessions. (up to 8 still images per visitor/session)• Night Vision with LED lights (illumination lamp):Door station is equipped with LED lights (illumination lamp). It enables the colour display of visitors at a distance of about 50 cm at night.For the Sub Monitor: AC adaptor × 1 (PNLV226), Rechargeable batteries × 2, Charger × 1 For the Door Station: Screw (3.8 mm x 20 mm) × 2For the Main Monitor Station/Extension Monitor: Mounting bracket × 1, Screw (4 mm x 16 mm) × 2Wiring Schematic DiagramAccessory InformationOptional AccessoriesWire type and lengthWiring run Wire type*4Diameter Length (Max.)Doorphone –Main monitor –Extension monitor*5φ 0.65 mm 22 AWG 100 mφ 1.0 mm 18 AWG 130 mφ 0.5 mm CAT 5 50 mMain monitor – Electric lock *6 φ 0.5 mm - φ 1.2 mm(24 AWG - 17 AWG)According to specificationof connected device.Main monitor – Connection devicefor option input (A contact) *6φ 0.5 mm - φ 1.2 mm(24 AWG - 17 AWG)According to specificationof connected device.Main monitor – PBX φ 0.65 mm CAT 3 or 22 AWG 100 m*1 When you use an additional doorphone, the maximum number of the electric locks that can be connected to thedoorphone depends on the type of doorphone. Consult your dealer for further information.For VL-V554 users:- Make sure to only connect electric vehicle gate locks to the S3/S4 terminals of the doorphones.- Make sure to only connect electric door locks to the S1/S2 terminals of the doorphones.*2 Connection devices for option input (A contact) can be used when a VL-V900 and VL-V700 series Video Intercom System for Apartment Complexes is used.- Make sure to connect emergency terminals to the IN1/IN2 terminals.- Make sure to connect doorbells to the IN3/IN4 terminals. A doorbell and doorphone 2 cannot be used together.*3 Connectable PBX Model Numbers: KX-TDA30/100/100D/200/600 series, KX-TDE100/200/600 series, KX-NS300/500/700/1000 seriesPlease consult your dealer when connecting with a PBX.*4 Type: Single-pair cable with outer sheath (jacket)Conductor: Copper solid• A certifi ed power supply wiring has to be used with this equipment. The relevant national installation and/orequipment regulations shall be considered. A certifi ed power supply wiring not lighter than ordinary polyvinylchloride flexible wiring according to IEC 60227 shall be used.*5 When an extension monitor is used, make sure that the total wiring length from the doorphone to the mainmonitor and then to the extension monitor, is within about 100 m.*6 When using an electric lock or a connection device for option input (A contact), select a device that meets thefollowing guidelines:• Electric lock connection terminal (S1/S2, S3/S4):- N/O dry closure contact- 30 V AC (1 A)/24 V DC (1 A) or lower• Connection device for option input (A contact) terminal (IN1/IN2/IN3/IN4):- Input method: No-voltage contact- Open-circuit voltage between terminals: DC 7 V or less- Detection definite time: 0.1 seconds or more- Short-circuit between terminals: 5 mA or less- Resistance value: make: 500 Ω or less, break: 15 KΩ or moreDECT RepeaterVL-FKD2Lobby StationVL-V590Up to 20 mainmonitors canbe connected.WirelessMonitor Station(Sub monitor)VL-WD613Door Station(Doorphone)VL-V522L(Surface mount)D1D2D3D4Ml-1Ml-2MO-1MO-2MO-3MO-4MO-5MO-6IN1IN2IN3IN4P1P212341920212256789101112131415161718S1S2S3S4Ml-1Ml-256Ml-1Ml-256Ml-1Ml-256MAIN MONITOREXTENSIONMONITOR 1EXTENSIONMONITOR 2EXTENSIONMONITOR 3Power plug(220-240 V AC)Connection device foroption input(A contact)*2DOORPHONE 1 *1DOORPHONE 2 *1(Optional lobby station or VideoIntercom System for ApartmentComplexes can be connected.)Terminal box(4-conductor wiring)PBX*3NP: Non-polarisedElectric lockPowersupplyPowersupplyElectric lockNPNPNPNPNPNPNPNPNPNPDoor Station (Doorphone)CMOS 0.3 M pixelsVL-V555 (Surface mount)CMOS 1.0 M pixelsVL-V554 (Surface mount)VL-V554U (Flash mount)Extension MonitorVL-MWD272VL-SWD272

/ 2

Related manuals for Panasonic VL-SWD272