Panasonic VL-SWD501AZ Quick Start Manual

Also see for VL-SWD501AZ: Installation guide

Panasonic VL-SWD501AZ Quick Start Manual Manual pdf 1 page image

Wireless Video Intercom SystemKey Features• Wireless Handset: Check visitors on Wireless Monitor, respond promptly and talk from living room, kitchen, everywhere home and while you are doing somethingelse. UP to 6 wireless monitor connectable. Max wireless range is 100m with no obstacles. You can add on repeaters expand the range. UP to 2 DECT repeater connectable.• Large Touch Panel: The main monitor has a large, 5 inch wide screen that clearly shows each visitor's face. You can simply touch the screen to activate anapproximate 2x zoom horizontally and vertically.• Electric Lock Release Support for Gate: The gate or door lock can be easily and quickly released even from the second floor of the house.• Wide-Angle Camera: Wide-angle lens covers approximately 170 degrees horizontally and 115 degrees vertically.• SD Card Recording: Automatically record video images of visitors to SD card. It will record up to 3,000 visitors (30 seconds per visitor).(The SD Memory Card is sold separately.)• Wireless Sensor Cameras: By installing the optional DECT Wireless Sensor Camera, you can use human (heat) and motion sensors to monitor locationsthat you are concerned about. UP to 4 wireless sensor camera connectable.• Night Vision: Door Station is equipped with LED lights (illumination lamp). It enables the colour display of visitors at a distance of about 50 cm at night.For the Sub Monitor: AC adaptor × 1 (PNLV226AL), Rechargeable batteries × 2, Charger × 1For the Door Station:

Mounting base × 1 & screw (3.8 mm x 20 mm) × 2, Screw (4 mm x 12 mm) × 4, Name plate × 2, Hex wrench × 1

Flush mounting box × 1, Screw (4 mm x 25 mm) × 4, Name plate × 2, Hex wrench × 1For the Main Monitor Station: Power supply unit* (VL-PS241) × 1, Mounting bracket × 1, Cable binder × 1, Screw (4 mm x 16 mm) × 2*Including AC cable × 1, Cable binder × 1, Screw (4 mm x 40 mm) × 2Wiring Schematic DiagramAccessory InformationOptional AccessoriesPOWER SUPPLY UNITDOORPHONE 1MAIN MONITORDOORPHONE 2220-240 V ACConnection device for option output (A contact)NP: Non-polarised12 V AC/DC12 V AC/DCElectric lockElectric lock24 V DCABDCCNP NPNPNPNPNPPowersupplyPowersupplyWire type and lengthWiring run Wire type*1Diameter Length (Max.)Main monitor – Doorphoneφ 0.65 mm 22 AWG 100 mφ 1.0 mm 18 AWG 130 mφ 0.5 mm CAT 5 50 mMain monitor – Power supply unit φ 0.65 mm 22 AWG 10 mφ 1.0 mm 18 AWG 20 mDoorphone – Electric lock*2 φ 0.5 mm - φ 1.2 mm (24 AWG - 17 AWG) According to specification of connected device.Main monitor – Connection device foroption output (A contact)*2 φ 0.5 mm - φ 1.2 mm (24 AWG - 17 AWG) According to specification of connected device.Wireless sensor camera –Power supply unit – φ 0.65 mm 22 AWG 50 mφ 1.0 mm 18 AWG 100 mWireless sensor camera –External sensor – φ 0.5 mm - φ 0.8mm (24 AWG - 20 AWG) According to specification of connected device.Must be no longer than 20 m.*1 Type: Single-pair cable with outer sheath (jacket) Conductor: Coppersolid• A certified power supply wiring has to be used with this equipment.The relevant national installation and/or equipment regulations shallbe considered. A certified power supply wiring not lighter than ordinarypolyvinyl chloride flexible wiring according to IEC 60227 shall be used.*2 When using an electric lock or a connection device for option output (Acontact), select a device that meets the following guidelines:• Electric lock connection terminal (S1/S2):- N/O dry closure contact- 12 V AC/DC, less than 1 A• Connection device for option output (A contact) terminal (OUT1/OUT2):- 24 V AC/DC, less than 0.3 A (minimum contact: 5 V DC 1 mA)VL-SWD501AZ/UAZBACDDoor Station(Doorphone)VL-V554BXVL-V554UBXDECT RepeaterVL-FKD2AZWirelessMonitor Station(Sub monitor)VL-WD613AZWireless Sensor CameraVL-WD812AZDoor Station(Doorphone)VL-V522LBXOptionalWireless Camera

/ 2

Related manuals for Panasonic VL-SWD501AZ