Panasonic VL-MN1000 Installation And Operating Instructions Manual

Panasonic VL-MN1000 Installation And Operating Instructions Manual Manual pdf 37 page image

12.7.3 Connecting the wires and cables1 Connect the LAN cable to the LAN connector.2 OptionalIf you are using a power supply unit to power the roommonitor, connect the DC plug to the DC IN connector.R See 12.6 Installing the power supply unit (soldseparately) (Page 31) for information aboutinstalling the power supply unit.3 OptionalIf you are connecting external devices, connect the12-pin terminal cable to the terminal connector.R See 12.8 Connecting external devices(Page 37) for information about connectingexternal devices to the 12-pin terminal cable.AB CA 12-pin terminal cableB DC plug from power supply unitC LAN cableNote:R Refer to 12.9 Wiring schematic (Page 38) forconnection diagrams.R Refer to 12.10 Wire and cable specifications(Page 38) for information on the type and length ofwires that can be used.12.8 Connecting external devicesUp to 6 external devices can be connected to the roommonitor. External devices are connected to the roommonitor by using the 12-pin terminal cable.Connecting devices to the 12-pin terminal cable1. Cut the 12-pin terminal cable in half.R Only one of the connectors is needed.2. Strip 5 mm from the ends of the wires that will be usedto connect to the devices.R Strip only the wires that will be used.R Refer to the diagram below for information aboutwhich type of device should be connected towhich wires.3. Solder the ends of the wires coming from the deviceto the corresponding wires of the 12-pin terminalcable. Use an insulation sleeve to insulate the wires.4. Insulate any exposed wires of the 12-pin terminalcable that are unused.HGABCDEFA Connect to urgency buttonB Connect to emergency buttonC Connect to doorbellD Connect to device #4 (type is programmable)E Connect to device #5 (type is programmable)F Connect to device #6 (type is programmable)G 12-pin terminal cableH Insulation sleeve3712. Installation

/ 40

Related manuals for Panasonic VL-MN1000