Panasonic UF-9000 Service Handbook

Also see for DP-180: Network scanner operations Service manual Operating instructions

39UF-9000JUN 2004Ver. 2.0DP-180/190B. Copying the Firmware from an Existing Machine using a Flash Memory Card (4 MB or 8 MB)1. Turn the Power Switch on the left side of the machine to the OFF position. (During a LightningStorm, to prevent electrocution disconnect the Telephone Line Cable first before unplugging the ACPower Cord.)2. Install a Flash Memory Card (4 MB or 8 MB) into the machine.3. Turn the Power Switch on the Left Side of the machine to the ON position.4. Press “FUNCTION”, “ORIGINAL SIZE” keys and then Key “3” on the keypad sequentially.5. Perform the Copy Service Mode F9-08 (Program Backup).6. The firmware is copied into the Flash Memory Card.7. After the backup is completed, press "STOP" first and then press "FUNCTION" + "CLEAR" keyssimultaneously to return to standby.8. Turn the Power Switch on the left side of the machine to the OFF position.9. Remove the Master Firmware Card that you just created from the machine.10. Turn the Power Switch on the Left Side of the machine to the ON position.11. Use this Master Firmware Card to update the firmware on other machines.2.5.6. Erasing the Master Firmware Card1. Turn the Power Switch on the left side of the machine to the OFF position. (During a LightningStorm, to prevent electrocution disconnect the Telephone Line Cable first before unplugging the ACPower Cord.)2. Install the Master Firmware Card into the machine.3. Turn the Power Switch on the Left Side of the machine to the ON position.4. Press “FUNCTION”, “ORIGINAL SIZE” keys and then Key “3” on the keypad sequentially.5. Perform the Service Mode F9-09 (Update Program Card).6. After the Flash Memory Card is erased, machine prompts “READY TO PROGRAM PRESS SET TOSTART”. Press “STOP”.7. Press "STOP" first and then press "FUNCTION" + "CLEAR" keys simultaneously to return tostandby.8. Turn the Power Switch on the left side of the machine to the OFF position.9. Remove the blank Flash Memory Card from the machine.10. Repeat from Step 2 above if you are erasing another Master Firmware Card.2.5.7. Notice after installing the HDD optionAfter the Hard Disk Drive Unit is installed, to prevent a Scan Disk Function from being performed (similarto Windows OS when the power is abruptly interrupted), it is important to follow the step sequence belowwhen turning OFF the Power Switch on the machine.1. If the machine is in the "ENERGY SAVER (Shutdown Mode)", you may turn the Power Switch onthe Left Side of the machine to the OFF position. If it is not in the "ENERGY SAVER (ShutdownMode)", continue to step 2 below.2. Press "FUNCTION" and "ENERGY SAVER" keys simultaneously first.3. Wait approximately 10 seconds while the machine writes the closing status onto the Hard Disk DriveUnit and advances into “ENERGY SAVER MODE”.4. Turn the Power Switch on the Left Side of the machine to the OFF position.5. Unplug the AC Power Cord. (During a Lightning Storm, to prevent electrocution disconnect theTelephone Line Cable first before unplugging the AC Power Cord.)6. After finishing the installation of the Hard Disk Drive, please go over the above Power Downprocedure with the customer to avoid the Scan Disk Function from being performed (indicated bySCANNING HARD DISK message on the display), and customer inquiries related to abrupt PowerOff.7. Reconnect the Telephone Line Cable if it was disconnected.