Panasonic TX-68P200A Operating Instructions Manual

Panasonic TX-68P200A Operating Instructions Manual Manual pdf 30 page image

30Remote Control VCR/LD/DVD OperationManufacturers’ Code SettingsThis remote control has been designed to work with a variety of VCRs, Laser Disc players and DVD players.In order for this to occur, the setting for the VCR, LD or DVD must be programmed into the Remote Control.1. To set a VCR, slide the remote control VCR-LD/DVD switch to VCR.To set a LD or DVD, slide the remote control VCR-LD/DVD switch to LD/DVD.2. Push the remote control VCR - LD/DVD Power Button and keep it Pushed.3. Enter the Manufacturer’s two-digit code number using the remote control Number Buttons(The codes are shown below).4. Push the STOP button .5. Release the remote control VCR or LD/DVD Power Button .6. Check the operation of the VCR, LD or DVD. If it does not operate correctly, repeat steps 1 to 5 anduse an alternate code (if there is one).VCR CODESManufacturer Code Manufacturer CodePanasonic / 10, 11, 12, 13 NEC 40, 41, 42, 43National ORION 45, 46AIWA 15, 16 Philips 50FUJITSU 20 SANYO 55, 56, 57, 58HITACHI 25, 26, 27 SHARP 60, 61JVC 30, 31, 32 SONY 65, 66, 67MITSUBISHI 35, 36 TOSHIBA 70, 71LD CODESManufacturer Code Manufacturer CodePanasonic 10, 11, 12, 13 SAMSUNG 30KENWOOD 15, 16 SHARP 35PHILIPS 20 SONY 40, 41, 42, 43PIONEER 25DVD CODESManufacturer CodePanasonic 70NOTES:1. If the batteries are removed from the remote control the Manufacturer’s codes are lost and must bereprogrammed.2. The list of manufacturer’s codes is given as a guideline only. Panasonic cannot guarantee that anyother manufacturer’s product will work with this remote control.