Panasonic TX-29AS10C Service Manual

Also see for QuintrixF TX-29AS10C/B: Operating instructions Service manual

Contents

Panasonic TX-29AS10C Service Manual Manual pdf 9 page image

ALIGNMENT SETTINGS:(The figures below are nominal and used for representative purposes only.)1. Set the Bass to maximum position, set the Treble to minimum position, set the Volume to minimum then press thedown button (-/v) on the customer controls at the front of the TV and at the same time press the INDEX button on theremote control, this will place the TV into the Service Mode.2. Press the RED / GREEN buttons to step up / down through the functions.3. Press the YELLOW / BLUE buttons to alter the function values.4. Press the STR button after each adjustment has been made to store the required values.5. To exit the Service Mode, press the "N" button.Alignment Function Settings / Special featuresHorizontal Position H-Pos061 Optimum setting.Vertical Position V-Pos005 Optimum setting.Horizontal Amplitude H-Amp055 Optimum setting.Vert. Amplitude V- Amp054 Optimum setting.EW-amplitude EW-Amp1- 030 Optimum setting.Lower corner Lower corner007 Optimum setting.Trapezium-comp Trapez 1047 Optimum setting.Upper corner Upper corner006 Optimum setting.Vertical Linearity V-Lin006 Optimum setting.Vertical Symmetry V-Sym002 Optimum setting.Angle Angle000 Optimum setting.Bow Bow005 Optimum setting.DVCO DVCO- 005Receive a PAL Colour Bar Pattern. ForDVCO alignment press "Blue" button, waituntil the colours are changing slowly andpress "STR".Cut-off DC Cut-off0171Ug2 TestUg20155O.K.To adjust Cutoff connect an oscilloscope tothe blue cathode, adjust "cutoff" valueusing the "Yellow" and "Blue" buttons untilthe black level is 160V ± 5V press "STR" tostore the value. Remove the oscilloscope.Select Ug2 adjustment and adjust thescreen VR until the display shows "O.K."HighlightLowlightHigh 0396 0357 0374Low 0117 0132 0112 Optimum setting.Sub-Brightness Sub-Brightness000 Optimum setting.Black Level160V ± 5VGND9