Panasonic TH-85PF12E Operating Instructions Manual

Also see for TH-85PF12E: Operating instructions Brochure & specs Operating instructions

Contents

Panasonic TH-85PF12E Operating Instructions Manual Manual pdf 59 page image

SLOT3PR /CR /R PB/C B/B Y/GCOMPONENT/RGB INLANAUDIO59Using Network FunctionThis unit has a network function to control the network connected display with your computer.Note:To use the network function, set each “Network Setup” setting and make sure to set the “Control I/F Select” to “LAN”.(see page 53)When “LAN” is set, the slot power is turned on, and power indicator is lit orange under the condition of power “Off” withremote control (stand-by state), regardless of the “Slot power” setting. (see page 56)Example of Network ConnectionCommand ControlHub or broadband routerLAN cable(not supplied)Notes:• Lay the LAN cable away from other connection cables (excluding the power cord).• Make sure the broadband router or hub supports 10BASE-T/100BASE-TX.• To connect a device using 100BASE-TX, use “category 5” LAN cable.• Touching the LAN terminal with a statically charged hand (body) may cause damage due to its discharge.Do not touch the LAN terminal or a metal part of the LAN cable.• For instructions on how to connect, consult your network administrator.Network function of the unit can control the unit in the same way as serial control from a network.Supported commandsCommands used in the serial control are supported. (see page 10)Note:Consult your local Panasonic dealer for detail instructions on command usage.Lessthan10 cmLessthan10 cmFerrite core(supplied)Ferrite core(supplied) Noise cut filter(supplied)Installing the Ferrite corePull back the tabs(in two places)Wind the cable twiceOpenPress the cable throughand closeSecuring the LAN cableClamperNote: In accordance with the Installation Instructions, secure the LAN cable so that it will not become near thedisplay unit.When using a pedestal (TY-ST85P12) for the installation of the display, use a clamper suppliedwith the display to secure the LAN cable. For use with another method of installation, refer tothe corresponding Installation Instructions.COMPUTERDisplay (main unit, rear)