Panasonic TH-47LFV5W Operating Instructions Manual

Also see for TH-47LFV5W: Service manual Operating instructions

Panasonic TH-47LFV5W Operating Instructions Manual Manual pdf 28 page image

28SCREEN SAVERChoose to enable the panel saving functions to reduce therisk of the “image persistence”.EXIT MENU:SEL +-:ADJ :RETURN :EXIT MENUSCREEN SAVERCOOLING FANBRIGHTNESSMOTIONAUTOOFFOFF• {COOLING FAN} - Select {ON} to turn on the cooling fanall the time. Select {AUTO} to turn on/off the cooling fanaccording to this Display’s temperature.NOTES:• The default {AUTO} option will start running the coolingfan if the temperature of 65 °C (152 °F) is reached,and will keep running for 30 minutes after coolingdown to the temperature of 62 °C (144 °F).• A temperature-warning message will be shown on thescreen once the temperature reaches 79 °C. All keyfunction except [Power] key will then be disabled.• Once the temperature reaches 80 °C (176 °F), thisDisplay’s power will be shut down automatically.• {BRIGHTNESS} - Select {ON} and the brightness ofthe image will be reduced to an appropriate level, andthe Brightness setting in the Picture menu will becomeunavailable.• {MOTION} - Select the time interval ({10 ~ 900} Seconds/ {OFF}) for this Display to slightly expand the image sizeand shift the position of pixels in four directions (up, down,left, or right).SIDE BORDER COLORAdjust the brightness of the black areas displayed on bothsides of 4:3 images.CONFIGURATION3 RESETReset all settings in the CONFIGURATION3 menu to factorypreset values.ADVANCED OPTION menu123SET EXIT MENU:SEL :NEXTINPUT CHANGETERMINAL SETTINGCOLOR SYSTEMSCAN MODESERIAL CONTROLLAN SETTINGADVANCED OPTION RESETFACTORY RESET:RETURN :EXIT MENUNORMALAUTOINITIAL INPUT OFFOVERSCANRS - 232CADVANCED OPTIONCALIBRATION DATA SAVECALIBRATION DATA LOADINPUT CHANGESelect the time for input switching as {NORMAL} or {QUICK}.NOTE: The selection {QUICK} may cause a slight noise.TERMINAL SETTINGSelect the mode to display the HDMI or DVI signal accordingto their signal format depending on their source device.• {DVI MODE}: Used for DVI-D signal.• Select {DVI-PC} when the source device is a PC.• Select {DVI-HD} when the source device is a videodevice.• {HDMI SIGNAL}: Used for HDMI signal.• Select {LIMITED} when displaying the signal that uses16 to 235 levels of 256 levels for each R, G, and B.• Select {FULL} when displaying the signal that uses all256 levels (from level 0 to 255).123EXIT MENU:SEL +-:ADJDVI-MODEHDMI SIGNAL:RETURN :EXIT MENUDVI-PCFULLADVANCED OPTIONTERMINAL SETTINGCOLOR SYSTEMSelects the Color System depends on your input video format.The options are: {AUTO} / {NTSC} / {PAL} / {SECAM} /{4.43NTSC} / {PAL-60}.NOTE: This item is functional for VIDEO input only.SCAN MODEChange this Display’s area of the image.• {OVERSCAN} - Display about 95% of the original size ofthe image. The rest of the areas surrounding the imagewill be cut off.• {UNDERSCAN} - Display the image in its original size.NOTE: This item is functional for HDMI-Video timing inputonly.SERIAL CONTROLSelect the nectwork control port.The options are: {RS-232C} / {LAN}.NOTE: If {LAN} is selected, then {RS-232C} will not beactivated, even if a cable is attached, and vice versa.