9AccessoriesWARNING:Do not disassemble or modify the pedestal.• Otherwise the Plasma Display may fall over and become damaged, and personal injury may result.CAUTION:Do not use any other Plasma Displays.• Otherwise the Plasma Display may fall over and become damaged, and personal injury may result.Do not use the pedestal if it becomes warped or physically damaged.• If you use the pedestal while it is physically damaged, personal injury may result. Contact your nearest Panasonicdealer immediately.During set-up, make sure that all screws are securely tightened.• If insufficient care is taken to ensure screws are properly tightened during assembly, the pedestal will not be strongenough to support the Plasma Display, and it might fall over and become damaged, and personal injury may result.Ensure that the Plasma Display does not fall over.• If the Plasma Display is knocked or children climb onto the pedestal with the Plasma Display installed, the PlasmaDisplay may fall over and personal injury may result.Two or more people are required to install and remove the Plasma Display.• If two or more people are not present, the Plasma Display may be dropped, and personal injury may result.••••••••Attaching the Pedestal to the Plasma DisplayAssembly screw (4)(silver)• XYN5+F18FNAssembly screw (4)(black)• THEL062NPole (2)• R:TBLA3689• L:TBLA3690Base• TBLX0132L RM5 X 18 M5 X 25A B C D■ Assembling the pedestalUse the four assembly screw A to fasten the left andright poles to the base securely.• Make sure that the screws are securely tightened.• Forcing the assembly screws the wrong way willstrip the threads.• "L" or "R" mark is stamped on the bottom of thepole.■ Securing the Plasma DisplayUse the four assembly screw B to fasten securely.• Make sure that the screws are securely tightened.• Carry out the work on a horizontal and levelsurface.ARDLFrontDBView from the bottomHole for pedestal installationArrow mark