29HOTEL MODE SetupItem DetailsInitial InputOff AV1 AV2 YPbPr HDMI1 HDMI2 HDMI PCAdjusts the input signal when the unit is turned on.Off: The input signal when the power was last turned off is set.Note:This menu is available only when "Input Lock" is "Off".Onscreen DisplayOff: Onscreen information is not displayed.On: Onscreen information is displayed.On 1: Onscreen information is displayed, except some RS-232C communication information is notdisplayed.Initial VOL LevelUsed to set the volume level at power-on.Off: The volume is set to the same level as when the power was last turned off.0 to 6: The volume is set to the selected level.Note:It is not possible to select an Initial VOL Level setting which is higher than the Maximum VOL Level setting.Maximum VOL LevelUsed to set the volume level so that it will not exced the maximum setting.Off: No restrictions are placed on the volume level.0 to 6: The volume is restricted to the selected level.Note:It is not possible to select a Maximum VOL Level setting which is lower than the Initial VOL Level setting.Input LockOff AV1 AV2 YPbPr HDMI1 HDMI2 HDMI PCLocks the input switch operation.Off: Input switch can be used.Button LockUsed to restrict the operation of the buttons on the main unit.Off: All the buttons on main unit can be used.Menu: Locks the Menu button on the main unit.On: Locks all the buttons on the main unit except the Power button.Remocon User LevelOff User1 User2 UserOff: You can use all of the buttons on the remote control.User1: You can only use POWER , INPUT, , MUTE, VOL buttons on the remote control.User2: You can only use POWER button on the remote control.User: Locks all the buttons on remote control.Note:Hotel Mode menu may not be accessed when you select "User2" or "User3". When this happens, pressand hold the VOL - key on the display, then press the OK button on the remote control. The message "Areyou sure to out the mode?" will appear, select Yes.Hotel Mode Menu List