Panasonic TH-32LHD7B Operating Instructions Manual

Panasonic TH-32LHD7B Operating Instructions Manual Manual pdf 9 page image

9Connections16 7 8394 51015141312112Notes:• Computer signals which can be input are those with a horizontal scanning frequency of 15 to 110 kHz and vertical scanningfrequency of 48 to 120 Hz. (However, the image will not be displayed properly if the signals exceed 1,200 lines.)• The display resolution is a maximum of 1,024 × 768 dots when the aspect mode is set to “4:3”, and 1,366 × 768 dots whenthe aspect mode is set to “16:9”. If the display resolution exceeds these maximums, it may not be possible to show finedetail with sufficient clarity.• The PC input terminals are DDC1/2B-compatible. If the computer being connected is not DDC1/2B-compatible, youwill need to make setting changes to the computer at the time of connection.• Some PC models cannot be connected to the set.• There is no need to use an adapter for computers with DOS/V compatible D-sub 15P terminal.• The computer shown in the illustration is for example purposes only.• Additional equipment and cables shown are not supplied with this set.• Do not set the horizontal and vertical scanning frequencies for PC signals which are above or below the specifiedfrequency range.Signal Names for D-sub 15P ConnectorPin Layout for PC InputTerminalPin No.12345Pin No.678910Pin No.1112131415Signal NameR (PR /CR )G (Y)B (PB/CB )GND (Ground)GND (Ground)Signal NameGND (Ground)GND (Ground)GND (Ground)NC (not connected)GND (Ground)Signal NameGND (Ground)SDAHD/SYNCVDSCLPC Input Terminals connectionAUDIOPC INTH-32LHD7COMPUTERConversion adapter(if necessary) D-sub 15pRGBPC cableFerrite core(Small size)(supplied)Less than10 cmStereo plugAudioConnect a cable which matchesthe audio output terminal on the computer.1 2 3Installing the ferrite core (Small size)Pull back the tabs(in two places)OpenPress the cablethrough and closeLess than10 cm