Panasonic TH-32LHD7B Operating Instructions Manual

Panasonic TH-32LHD7B Operating Instructions Manual Manual pdf 27 page image

27Reduces power consumptionPress to select“Power save”“Standby save”“Power management”“Auto power off”.Press to select “On” or “Off”.On OffPress to exit from Setup.• Power save: When this function is turned On, luminous level of the LCD Display is suppressed, so powerconsumption is reduced.• Standby save: When this function is turned On, power consumption of the microcomputer is reducedduring power supply standby (see page 12, 14-15), so standby power of the set is reduced.• Power management: The unit power supply is turned On or Off depending on whether or not there is a signalduring PC input mode.This function is enabled when it is turned On. (Only during input from PC (MiniD-sub) terminal)• Auto power off: Equipment power supply is turned Off when there is no signal.When this is set to On, the power supply of the unit goes Off 10 minutes after the inputsignals stop.This function is effective for input signals except input from PC (Mini D-sub) terminal.Press to select Input label.Press to change the Input label.Customizing the Input labelsThis function can change the label of the Input signal to be displayed.Note:While selecting an Input signal through Optional Terminal Board connected to Slot1 and Slot2, the Input label willdepend on each Optional Terminal Board.Input labels for Slot1, Slot2 and miniD-sub:[Slot1 Input] INPUT1 / VIDEO1 / COMPONENT1 / RGB1 / DIGITAL1 / PC1 / DVD1 / CATV1 / VCR1 / STB1[Slot2 Input] INPUT2 / VIDEO2 / COMPONENT2 / RGB2 / DIGITAL2 / PC2 / DVD2 / CATV2 / VCR2 / STB2[PC (MiniD-sub) input] PC / COMPONENT / RGB / DVD / STBSET UPNote:“Power management” and “Auto power off” are effective during normal viewing (one picture screen) only.1/2PCOffStandby save OffPower management OffAuto power off OffOSD Language English (UK)Component/RGB-in selectRGBInput labelSignalPower saveSetup1/2PCOffStandby save OffPower management OffAuto power off OffOSD Language English (UK)Component/RGB-in selectRGBInput labelSignalPower saveSetup123