7Precaution on battery useIncorrect installation can cause battery leakage and corrosion that will damage the remote controltransmitter.Observe the following precautions:1. Always use new batteries when replacing the old set.2. Do not attempt to charge, short-circuit, disassemble, heat or burn used batteries.3. Battery replacement is necessary when remote control acts sporadically or stops operating this unit.Notes:• Do not drop, apply shock to or step on the remote control.• Do not spill water on the remote control.• Do not place objects between the remote control and remote control receiver.• Do not use remote controls for other equipment at the same time.• If the TV does not operate even when operating the remote control from a close range, it is time toreplace the batteries.Refer to the label on back of the remote control for directions on replacing batteries.Requires two AA batteries.1. Open the battery cover. 2. Install the batteries as shownin the battery compartment.(Polarity + or – must match themarkings in the compartment).3. Replace the cover.Replacing batteriesReplace batteries by following the steps below:InstallationRemote control battery installationCAUTION :If water or similar substances get inside the monitor via the liquid crystal panel surface, a malfunction may result.To clean this unit, wipe with a soft, dry cloth.If the surfaces are extremely dirty, use a soft cloth dipped in a soap andwater solution or a weak detergent solution.• Use eyeglass cleaner to remove stubborn dirt from the LCD.• Never use alcohol, paint thinner or benzine to clean this unit.• Before using a chemically treated cloth, read the instructions that camewith the cloth carefully.MilddetergentMaintenanceTwo AA size