Panasonic Switch-S24GPWR Installation Manual

Also see for PN25249-ID: Operation manual

Contents

Panasonic Switch-S24GPWR Installation Manual Manual pdf 15 page image

15When the requested power supply of the Switching Hub exceeds 124 W, causing an overload, you cancheck a port that stopped supplying power by changing the mode LED display to that of PoE mode.Remove the cable from the port with its LED blinking orange to reduce the requested power supply ofthe Switching Hub to 124 W or below.You can set/change the priority of the power supply from the console.(By factory default, the same priority is given to all Ports 1 to 24.)Ports 1 to 24 support IEEE802.3af PoE. This function allows for power supply of up to 15.4 W througheach port and 124 W in total through the Switching Hub. PoE power supply function operation overview Power supply while the PoE LIM. LED is blinking orange (overload caused bythe total power supplied by the Switching Hub)When the requested power supply of a single port exceeds 15.4 W, causing an overload, the powersupply is stopped. You can check a port that stopped supplying power by changing the mode LEDdisplay to that of PoE mode.Remove the cable from the port with its LED blinking orange.Caution: 1) Some PoE-powered devices may have a large difference in power consumption betweentheir maximum power use condition and normal condition. Carefully configure them sothat the upper limit of power supply will not be exceeded.2) If you don't set a priority for power supply or if the same priority is given, note that thepower supply priority is assigned to the ports in ascending order of the port numbers.(When the requested power supply exceeds 124 W, power supply to a port with a higherport number will be stopped first.) Power supply while the overload is caused by a single port2.2 PoE power supply function* For configuration and management method, please see the PDF version OperatingInstructions in CD-ROM.Port LEDs (left) 1 to 24 (with the PoE modeLED turned on)Green Light: Supplying power normally.Orange Blink: Overload caused by a single port.(Requested power is exceeding15.4 W.)Off: Not supplying power or noPoE-powered device connected.PoE LIM. LED (PoE limit)Off: Supplying power in the range from0 to 117 W.Green Light: Supplying power in the range from117 to 124 W.Orange Blink: A single port's power supply isexceeding the upper limit, or thetotal power supply of theSwitching Hub is exceeding 124 W.