61Customizing Your MachineNo. Parameter SettingNumber Setting Comments13 AUTO JOURNAL PRINT 1 Invalid Selecting whether the machine prints the journal automaticallyafter every 32 transactions.2 Validafter every 32 transactions.14 FILE ACCEPTANCEREPORT1 Invalid Selecting whether the machine prints the file acceptance journal.If you set this parameter to valid, the journal will be printed outREPORT2 ValidIf you set this arameter to valid, the journal will be rinted outafter entering any communications using memory.17 RECEIVE MODE 1 Manual Setting the reception mode to either automatic or manual.2 Auto22 SUBSTITUTE RCV 1 Invalid Selecting whether the machine receives to memory whenrecording paper runs out, toner runs out or recording paper is2 Validrecording a er runs out, toner runs out or recording a er isjammed.24 PRINT REDUCTION 1 Fixed Selecting print reduction mode.Fixed:Reduce received document according to the setting ofParameter No 252 AutoParameter No. 25.Auto: Reduce received document according to the length ofreceived documents.25 REDUCTION RATIO 70 70% Selecting fixed print reduction ratio from 70% to 100%. Thisparameter functions only when fixed print reduction is selected arameter functions only when fixed rint reduction is selectedon fax parameter no. 24.100 100%26 POLLING PASSWORD (----) Setting a 4-digit password for secured polling.28 STAMP AT MEM. XMT 1 Invalid Selecting whether or not the machine stamps the originaldocuments when storing the documents into memory.2 Validdocuments when storing the documents into memory.(depending on the Stamp setting on the Control Panel.)30 DRD SERVICE 1 Invalid Selecting whether or not the machine is available ”DRDService”. If this parameter is set to ”Valid”, your machine detectsh ifi d i l i d2 Valid, ythe specified ring pattern only to receive a documentautomatically.32 COPY REDUCTION 1 Invalid Selecting whether or not the machine performs copy reduction inaccordance with the setting of Parameter No. 24 and 25.2 Validaccordance with the setting of Parameter No. 24 and 25.33 XMT REDUCTION 1 Invalid Selecting whether the machine performs reduction when thetransmitting document is wider than the recording paper used at2 Validtransmitting document is wider than the recording a er used atthe receiving machine.34 POWER SAVE TIMER 000 – 120 min. To reduce the power consumption in standby, specify the numberof minutes the printer remains idle before turning off the highof minutes the printer remains idle before turning off the hightemperature fuser unit.Continued on the next page.0300200000203002080001#@multitude03002080084030020800130300208006003002080019030020800810300208002203002080023030020800850300208004903002080027030020800970300208009803002990001#@multitude
