Menu
Panasonic MCO-170AICL Operating Instructions Manual
                                                                                         |
15INSTALLATIONInstallation siteFor correct operation of the incubator, install it in a location with the following conditions.WARNINGWhen using CO 2 gas for control, make sure that there is an adequate ventilation. Using CO2 gas in asmall room without adequate ventilation may cause gas poisoning or oxygen deprivation. In addition, whenopening the incubator doors, do not directly inhale the air in the chamber.Si l’appareil est utilisé dans un evdroit restreint, le niveau de la densite CO 2 de l’air peut s’élever et peutêtre nocif aux humains. Evitez d’aspirer l’air provenant de l’inérieur de l’appareil quand vous ouverz laporte. Normal air environmentInstall the incubator in an environment with normal air. Do not expose to direct sunlightDo not install the incubator in a location where it will be exposed to direct sunlight. If the incubator isoperated in direct sunlight, performance will be adversely affected. Separate from heat sourcesDo not install the incubator near significant heat sources, such as heaters, boilers, ovens, or autoclaves.Heat will adversely affect the performance of the incubator. Ambient temperature at least 5 C lower than set temperatureThe control temperature of the incubator is at least 5 C higher than the ambient temperature. For example,if the chamber is controlled at 37 C, the ambient temperature must be 32 C or less. Do not allow theambient temperature to become too high. Strong and level floorSelect a site with a strong and level floor. If the floor is uneven or the installation is not level, the incubatorwill be unstable and this may cause accident or injury. To avoid vibration and noise, always make sure thatthe installation is stable. An unstable surface may result in vibration or noise.WARNINGInstall the incubator at a location that can support the weight. If the floor is not strong enough or if theinstallation is insufficient, the incubator may fall over and cause injury.Always make sure that the floor is strong, even, and level, and that the incubator will not tip over.An insufficient installation may result in injury due to water leakage or the incubator falling over. Low humiditySelect a site with a relative humidity of 80 %R.H. or lower. Using the incubator in high humidity may resultin current leakage or electric shock.WARNINGDo not use the incubator outdoors. If the incubator is exposed to rain water, it may result in currentleakage or electric shock.Never install the incubator in a moist location, such as near a sink or water line, or where it is likelyto be exposed to water. In addition, do not install it near water or steam pipes. Moisture can cause theinsulation to deteriorate, which may result in current leakage or electric shock. |
This manual is suitable for:
Product
Learn More
Legal
Copyright © 2024 OneStart. All Rights Reserved