8.2 Quick SetupProgramming Manual 113• While downloading system data from the PBXThe Firmware Upgrade screen will be displayed automatically. Reselect the systemsoftware file and perform the upgrade again.• While writing the new software to the PBXThe PBX will be unable to start properly. The Firmware Upgrade screen will bedisplayed automatically. Reselect the system software file and perform the upgradeagain.• While restoring system data to the PBXThe Firmware Upgrade process will be automatically restarted from this step, andsystem data will be restored to the PBX.8.2 Quick SetupAllows basic settings of the PBX to be modified easily.This option can be accessed in either of 2 ways:• Automatically when connecting to the PBX for the first time or after the PBX data has been cleared.• Manually, by selecting Quick Setup from the Utility menu.This option only runs automatically when the following conditions are met:• The user is logged on to Maintenance Console using the Installer level programmer code.• The date and time of the PBX have not yet been set.• The model code of Maintenance Console and PBX match.• The user has selected to connect Maintenance Console to the PBX in Interactive mode.It can be run manually when the following condition is met:• Maintenance Console is connected to the PBX in Interactive mode.When the Quick Setup wizard is started manually, it is possible to cancel the wizard at any point by clickingthe Cancel button. No changes will be made to the PBX. However, the Cancel button is not available whenQuick Setup runs automatically upon connection to the PBX. In addition, when Quick Setup runs, it showsonly default data for all programmable parameters. Any existing settings are not shown, and will beoverwritten, so run Quick Setup manually only when necessary.Using Quick Setup, the following basic parameters can be programmed as desired:• The date and time. The PBX uses the date and time set to the PC. (→9.1.1 Date & Time [1-1])• The system password. (→9.1.2 Main [1-2])• The operator extension number. (→1.1.87 Operator/Manager Features in the Feature Manual)• Automatic Configuration for CO Line Type (DTMF/Pulse). (→1.1.5 Automatic Configuration forOutside (CO) Line Type in the Feature Manual)• Extension numbers and names. (→1.1.69 Intercom Call in the Feature Manual)• Ringing assignment for each outside line (either all extensions, or a specific extension). (→1.1.90Outside (CO) Line Ringing Selection in the Feature Manual)
