2.2 PT Programming—Procedures76 Programming Manual[913] Call Waiting Caller ID AssignmentEnables the Call Waiting Caller ID feature for each outside (CO) line that has had Caller ID Servicecontracted from the telephone company.Conditions• When the Caller ID feature is disabled in [900] Caller ID, the Call Waiting Caller ID feature doesnot function even if it is enabled here.Programming Manual References[900] Caller IDFeature Manual References1.1.28 Call Waiting Caller ID[914] Call Waiting Caller ID CAS Receive TimeSelects the allowable CAS (CPE [Customer Premise Equipment] Alerting Signal) duration. Normally, itshould not be necessary to change the default setting.If the extension user has a Call Waiting Caller ID during a conversation, the telephone company will sendan alert tone (CAS) to the PBX. If the CAS duration is too long or too short, the CAS is ignored by the PBX.If the CAS is accepted, then the PBX will respond and the Call Waiting Caller ID feature will be performed.Conditions• This program is available when the Caller ID and Call Waiting Caller ID features are enabled in[900] Caller ID and [913] Call Waiting Caller ID Assignment.Programming Manual References[900] Caller ID[913] Call Waiting Caller ID AssignmentFeature Manual References1.1.28 Call Waiting Caller ID9 1 3 NEXT CO line no. STORE END(1…8/ )SELECTSELECTNEXT PREVorTo continueTo continue( Enable/Disable)9 1 4 NEXT(Mode 1: 40-120 ms/Mode 2: 64-96 msMode 3: 72-96 ms)ENDSELECT STORE
