6.2 DisconnectProgramming Manual 101The parameters are as follows:6.2 DisconnectDisconnects the PC from the PBX. Data transmission ends, and Maintenance Console returns to Initialmode.To disconnect• From the Connect menu, select Disconnect.If there is data that has been edited but not yet sent to the PBX, a confirmation window will be displayed.• Click Yes to send the data to the PBX.• Click No to discard the data.Parameter Values ExplanationDial Number 0-9, *, #, "-" (hyphen)and "," (comma)Telephone number to be dialed to access thePBX.Dial Type Auto (Tone), Auto(Pulse), ManualOutgoing dialing method. If "Manual" isselected, a telephone must be connected inparallel to dial.Comment – Enter a comment to help to identify this profile.Port COMx Specify the number of the COM port assignedto the PC's modem interface. Only availableCOM ports will be displayed.Baud Rate (bps) 1200, 2400, 4800, 9600,19200, 38400, 57600,115200Specify the speed of data transmission.Flow Control None, Hardware Specify whether the rate of data transfer ismanaged by hardware or not.Modem Initialize Default, Custom Specifies the command used to initialize themodem. If "Custom" is selected, enter theinitialize string in the text box. Refer to yourmodem's instruction manual for more details.Initialize – Click to send the specified initialize string to themodem.
