2-2 Station Programming (Personal Programming)2.1 Station Programming InstructionsWhen storing dataAfter pressing the STORE button to store data, you may hear one of the following tones.— Confirmation tone (one beep): storage is completed.— Confirmation tone (two beeps): the data is the same as the last entry.— Alarm tone (three beeps): the entry is not valid.To exit the Station Programming modeStation Programming allows you, the proprietary telephone (PT) user, to program certainfeatures from your telephone individually. To program, you need to switch your telephoneto the Station Programming mode. During the programming mode, your telephone isbusy to outside callers. If you want to make a normal call operation, you must finish theprogramming mode.Programming Mode DisplayWhen you enter the Station Programming mode, the display shows the following messageas the initial programming mode.The display also gives you helpful or stored data information related to the programmingsteps. In this section, the display example in the programming steps are noted, if required.You can also refer to the “Display Examples” in the Appendix (Section 5).To enter the Station Programming modePITS-PGM NO? →PTSET PROGRAMMEMORYSet the MEMORY switch to “PROGRAM”.Be sure the telephone is idle and on-hook.PTSET PROGRAMMEMORYSet the MEMORY switch to “SET”.When the display shows the initial programming modeProgramming is completedand the normal call operationresumes.
