Tone TimingsDescription Specifies the pattern, in milliseconds, of dial tones using up to 10whole numbers (off 1, on 1, off 2, on 2…) separated by commas.Note• The unit will not play the tone for the duration of the first value,play it for the duration of the second value, stop it for theduration of the third value, play it again for the duration of thefourth value, and so on. The whole sequence will then repeat.For example, if the value for this setting is "100,100,100,0", theunit will not play the tone for 100 ms, play it for 100 ms, stop itfor 100 ms, and then play it continuously.• It is recommended that you set a value of 60 milliseconds ormore for the first value (off 1).Value Range 0–16000 (0: Infinite time)Note• Avoid setting 1–50 for any of the values.Default Value 60,0Configuration File Reference DIAL_TONE1_TIMING4.6.5.2 Busy ToneTone FrequenciesDescription Specifies the dual-tone frequencies, in hertz, of busy tones using 2whole numbers separated by a comma.Value Range 0, 200–2000 (0: No tone)Note• If the value for this setting is "480,620", the unit will use amixed signal of a 480 Hz tone and a 620 Hz tone.Default Value 480,620Configuration File Reference BUSY_TONE_FRQTone TimingsDescription Specifies the pattern, in milliseconds, of busy tones using up to 10whole numbers (off 1, on 1, off 2, on 2…) separated by commas.Value Range 0–16000 (0: Infinite time)Note• Avoid setting 1–50 for any of the values.Default Value 60,500,440Configuration File Reference BUSY_TONE_TIMING4.6.5 Tone Settings132 Administrator Guide Document Version 2016-05
