1.1 Setup1.1.1 Factory DefaultsMany of the settings for this unit have been configured before the unit ships.Where possible, these settings are configured with the optimum or most common values for the setting. Forexample, the port number of the SIP (Session Initiation Protocol) server is set to "5060".However, many of the settings, such as the address of the SIP server or the phone number, have not beenpre-configured, and they must be modified depending on the usage environment. If the port number of theSIP server is not "5060", the value of this setting must be changed.This unit thus will not function properly using only the factory default settings. The settings for each featuremust be configured according to the environment in which the unit is used.Note• If you are using a PoE hub, the number of devices that you can connect simultaneously is limited bythe amount of power supplied by the hub.1.1.2 Language Selection for the UnitYou can change the language used on the LCD.In addition, various settings can be configured by accessing the Web user interface from a PC on the samenetwork (→ see 4 Web User Interface Programming). You can select the language for the Web userinterface.Note• To select the display language for the unit, refer to the Operating Instructions on the Panasonic Website (→ see Introduction).• To select the display language for the Web user interface, see 4.4.1 Language Settings.1.1.3 Basic Network SetupThis section describes the basic network settings that you must configure before you can use the unit onyour network.You must configure the following network settings:• IP Address Mode (IPv4 or IPv6 or IPv4/IPv6 Dual) settings• TCP/IP settings (DHCP / RA for IPv6 / static IP)• DNS server settingsFor details about basic network settings via the Web user interface, see 4.3.1 Basic Network Settings.TCP/IP Settings for IPv4 (DHCP or Static IP Address Assignment)A unique IP address must be assigned to the unit so that it can communicate on the network. How youassign an IP address depends on your network environment. This unit supports the following 2 methods forassigning an IP address:Obtaining an IP Address Automatically from a DHCP ServerYou can configure the unit to automatically obtain its IP address when it starts up from a DHCP serverrunning on your network. With this method, the system can efficiently manage a limited number of IPaddresses. Note that the IP address assigned to the unit may vary every time the unit is started up.For details about the DHCP server, consult your network administrator.1.1 Setup10 Administrator Guide Document Version 2016-05
