Panasonic Diga DMR-BS750EB Operating Instructions Manual

Contents

11RQT9430Quick Start Guide STEP 2When your television has a digital satellite tunerBSatelliteThis unitTVAVHDMI INAVHDMIOUTAV1 (TV)HDMI cable (not supplied)21-pin Scart cable (not supplied)DISH IN 1DISH IN 2To householdmains socket AC INÚConnect only after all other connections are complete.After completing the connections, proceed to the TV Tuning (➔ 13).Refer to page 120 if “U50”, “U50 1” or “U50 2” appears on the unit’s display.HDMI featuresPlease use High Speed HDMI Cables that have the HDMI logo (as shown on the cover).When outputting 1080p signal, please use the HDMI cables 5.0 meters or less.Set “HDMI Video Mode” and “HDMI Audio Output” to “On” (➔ 105). (The default setting is “On”.)This unit incorporates HDMI™ (V.1.3a with Deep Colour, x.v. Colour™, High Bit rate Audio) technology(➔ 138, 139).Video sources converted to 1920 × 1080 resolution, while of high quality, will exhibit somewhat lower subjectiveimage resolution than true, native 1080p full-HD sources. See dealer for details.NotesThe freesat channel uses Astra 2 at 28.2° East, and Eurobird 1 at 28.5° East satellites. To ensure your satellitedish is correctly installed please consult your freesat registered dealer.If you connect 2 satellite dishes for different satellites (e.g., DISH IN 1: Astra 28.2, DISH IN 2: Astra 19.2), the unitcannot receive the signal correctly.You can use the unit as one tuner when connecting DISH IN 1 to a satellite dish that can receive SKY.If connecting to equipment that is only compatible with 2 channel audio output, audio with 3 channels or more willbe down-mixed (➔ 138) and output as 2 channels, even if connecting with an HDMI cable (some discs cannot bedown-mixed).For display units compatible with HDCP (High-Band width Digital Content Protection) that are equipped with adigital DVI input terminal (PC monitors, etc.):Depending on the unit, picture may not display properly or at all when connecting with a DVI/HDMI switching cable(audio cannot be output).If you connect a DVI device that is not compatible with HDCP, set “HDCP on HDMI Output” in the Setup menu to“Off” (➔ 105).TipsYou can check the satellite signal condition using “Signal Condition” in the Setup menu (➔ 98).When the unit is not to be used for a long timeTo save power, unplug it from the household mains socket. This unit consumes a small amount of power,even when it is turned in standby.[approx. 0.4 W (“Power Save” is set to “On”)]••••••••••••Connecting with aPanasonic TV (VIERA)If the 21-pin Scart cable isconnected, the Direct TVRecording and Pause LiveTV function is available whenyou view other than satelliteprogramme. (➔ 37)