Panasonic CT-27G30CT Operating Instructions Manual

Also see for CT-27G30CT: Operating instructions

Panasonic CT-27G30CT Operating Instructions Manual Manual pdf 10 page image

Control OperationPower B utton - Pressthe POWER button to turnON. Press again to turn OFF.POWERVolume Button - Press the VOLUME (VOL)LEFT or RIGHT button for desired listening level (whenOn Screen Menus are not displayed).DecreasesVolume LevelIncreasesJme LevelLocated On Remote ControlChannel Change - (Twooptions)Option 1.Press the CHANNEL (CH) UP or DOWN button tosequentially scan through programmed channels(when On Screen Menus are not displayed).NOTE: TV/AUX/CABLE switch (located on Remote)must be set in TV position. TV/AUX/CABLELocated On Remote ControlSelects NeLowerChannelSelects NextHigher ChannelOption 2.Press two digits on keyboard (Example press 0,then 5 for channel 05). For channels over 99, pressthree digits on keyboard.Mute Button - Press the MUTE button to quicklyreduce sound level (Mute will appear on screen). Pressagain to restore sound.MUTEHelpful Hints:• Helpful information will display On Screen momen-tarily when Receiver is first turned on and when thechannel is changed.• When using keyboard entry for channels 10,11 and12 in the CABLE mode there is a slight delay beforechannel change because of the capability of tuningcable channels 100 to 125.• If you do not receive channels above 13, confirm thetype of signal at ANT Input (TV or Cable) and set theTV or Cable Tuning Mode accordingly. (Refer to SetUp Feature, Antenna selection.)NOTE: If "SPEAKER OFF" is displayed On Screenafter pressing the VOLUME button, refer toAudio Menu to turn Speakers "ON".]I® ® ®1I1® ®1II® ® ®1I_c ikVCR Function Buttons - TheVCRFUNC-TIONbuttons have been designed to operate numerousbrands of VCRs. The infra-red code must be obtainedpriorto use. (Please refer to Programming the UniversalRemote for programming instructions.)NOTE: The TV/AUX/CABLE switch (located on Re-mote) must be in the AUX position (Center). TheVCR-LDP switch must be in the VCR position.TVlAUX/CABLEVCR IPOWER RECORD IF-1 r"-n _REW PLAY FFMOVE SIZE PIPTVNCR STOP PAUSEr-1Fi-7 r-7FREEZE SWAPvCR/LDP VCR CHANNEL-10-