Panasonic CF-48 Series Reference Manual

Also see for Toughbook CF-48 Series: Reference manual Operating instructions Reference manual Service manual Reference manual

Panasonic CF-48 Series Reference Manual Manual pdf 52 page image

52Technical InformationNetworkWhen the power saving function is running, communications software may malfunc-tion. For example, communications may be halted if the standby (hibernation) modeis activated. The computer must be restarted if one of these modes is entered duringdata communications.Be sure that the power of the display is cut (for energy conservation purposes) or thecomputer enters standby (hibernation) mode after the communications software isclosed.The network connection may be severed under the condition thepower of the display is off (for energy conservation purposes) andstandby (hibernation) mode. When network or communication soft-ware is to be used, set [System standby], [Turn off monitor] and [Turnoff hard disks] (in [Start] - [Settings] - [Control Panel] - [Power Man-agement]) to [Never].The network connection may be severed when entering the ECOmode and hibernation mode. The computer will not operate properly.If this occurs, restart the computer.The network connection may be severed under the condition thepower of the display is off (for energy conservation purposes) andstandby (hibernation) mode. When network or communication soft-ware is to be used, set [System standby] and [System hibernates],[Turn off monitor] and [Turn off hard disks] (in [Start] - [Settings] -[Control Panel] - [Power Options]) to [Never].Windows 98Windows NTWindows 2000When using the files in the following folders available on the retail version of the Win-dows CD-ROM, it is necessary to run a separate file decompression program.\tsclient\toolsTo uncompress the file, it is necessary to have approximately 80 MB of free disk spaceavailable on the hard disk.To use the CD drive in MS-DOS mode, perform the operation below after modifyingconfig.sys and autoexec.bat ( page 27).File decompression method:1 Turn your computer on.2 When [Press to enter SETUP] is displayed, immediately press Ctrl (until themenu is displayed).3 Select [Command prompt only].4 Insert the Product Recovery CD-ROM.5 At the prompt, input the following:L:\en\addfile EnterFollow the on-screen message .After this program is executed, the contents of the above folders will be decompressedto the c:\util\win98add folder.When using the Files on the Retail Version of the Windows CD-ROM Windows 98