Panasonic CF-25 Operation Instructions Manual

Also see for CF-25: Operating instructions Operating instructions Operating instructions Operating instructions

Panasonic CF-25 Operation Instructions Manual Manual pdf 22 page image

2 2Hardware ExpansionDevices capable of being used by your computer are listed in the table below.PC Card Slots page 23Serial Port page 43Multimedia Pocket belowMultimedia Pocket belowRAM Module Slot page 24Ext. Display Port page 25Parallel Port page 26Expansion Bus Connector page 26Ext. Keyboard/Mouse Port page 42Headphone Jack page 42D e v i c e ( s )PC Cards (Modem, LAN, SCSI, etc.)Serial Devices (Mouse, Modem, etc.)CD-ROM drive (CF-VCD252)Second Battery Pack (CF-VZS252)Extra MemoryExternal DisplayPrinterPort Replicator (CF-VEB251)Keyboard, External Mouse [Type PS/2], etc.Speaker/HeadphoneR e f e r e n c eW h e r e t o c o n n e c tThe multimedia pocket houses the floppy disk drive (FDD) that comes with this computer. TheFDD can be replaced with an optional unit.[CD-ROM Pack (CF-VCD252), Second BatteryPack (CF-VZS252)].Using a multimedia pocket device2 Removing a multimedia pocket device1Inserting a multimedia pocket deviceC A U T I O NIn the suspend mode, do not remove/change the multimedia pocket device. Re-moving the device in the suspend mode will erase your data and may damage thedevice.Push the unit in until it snaps into place. Confirm that the MP release has returned toits original position.Slide the MP release toward the MP device. The MP device should slide out.Power off your computer ( page 10)Do not shut down using the suspend mode.32Pull out the device.Installing/Removing a multimedia pocket deviceTurn your computer over and open the cover21c o n n e c t o rC A U T I O NMake sure that the position of the peripheral connector is located as shown inthe illustration.Gently install / remove any multimedia pocket device. Do not use excessiveforce when installing.C A U T I O NYou may use the floppy disk drive as an external unit that is connected through theparallel port, by using an optional FDD cable (CF-VCF351). Some precautionsare necessary, as described below, since problems may arise.Do not move the drive while accessing data on the floppy.Firmly hold both sides of the drive when removing a disk. Excessive force ontop should be avoided.1The "Software Preparation (first time only) Windows 95 model" described in the Operating Instructions of the CD-ROM Pack has been changed. The following settings are necessary in order to prepare the CD-ROM Pack for use:1 Select [Start] - [Settings] - [Control Panel] - [System] - [Device Manager] - [CD-ROM] - [MATSHITAUJDCD8715]- [Settings]. Set [Start drive letter] and [End drive letter] of [Reserved drive letter] to [L].2 Clear the check mark from [Auto insert notification] under [Options]. If this setting is omitted and power savingmode is turned on (using the Setup Utility), the power saving mode is still disabled. Also, charging takes placeintermittently, even during charging, so the battery indicator periodically lights and goes dark.3 Select . Follow the instructions that appear on the screen to restart the computer..Even after installing the CD-ROM Pack or Second Battery Pack, "Removable Disk (A:)" is displayed in "My Com-puter", but access is not possible. When the display appears, select [Cancel].N O T E