1 4Use the Battery Indicator to Check on the Battery Status( page 15)Battery StatusB a t t e r y I n d i c a t o r B a t t e r y S t a t u sChargingFully-chargedBattery charge is low (the charge is less than approx. 9% capacity)Battery pack or charger may not be working properly.Check your connections. If the problem persists, consult yournearest Panasonic dealer.Unable to recharge due to violation of temperature limits( page 15)RefreshingRefreshing requiredO r a n g e *G r e e n *R e dB l i n k i n g r e d *B l i n k i n g o r a n g e f o r 5s e c o n d s a f t e r t h e A Ca d a p t e r i s c o n n e c t e d *B l i n k i n g o r a n g e * *B l i n k i n g g r e e n * ** When the AC adapter is connected, you must wait a few seconds before the LED indicator turns on.** Only using CF-VZS250A or CF-VZS252 (Ni-MH).N O T EWhen the Remaining Battery Charge Becomes LowPerform the following:Plug in the AC adapter, and fully charge your battery.Use a spare battery if you have one.If you have neither the AC adapter nor an extra battery, power the computer off or donot power on.If the hibernation function is setC o m p u t e rgoes off(at approx. 0% capacity)If the hibernation function is not set(at approx. 9% capacity)Red indicator lightsBeep sounds**When using the optional CD-ROM pack:Recharging is temporarily stopped when the drive is being accessed. In the case, the batteryindicator goes off temporarily. In addition, recharging is temporarily discontinued when the CD-ROM autoplay function is enabled. For more information, please read the operating instructionsthat is supplied with the CD-ROM pack.(at approx. 9% capacity)Red indicator lights Beep sounds(at approx. 4% capacity)(at approx. 4% capacity)Hibernation Mode** When disabling the speakers with the Setup Utility (or pressing + ), the warning beep is alsodisabled.Getting a detailed reading +N O T EWhen the battery indicator remains red (or a 99% reading is displayed) for anextended period of time, the actual remaining battery level and the displayedlevel may differ. Should this occur, charge the battery until the indicator is green,then completely discharge the battery.When the battery pack is not in the computer, is displayed.90 ~ 100%65 ~ 90%35 ~ 65%10 ~ 35%[Blinking]The battery pack is not installed orthe remaining battery charge is notknown.Computing On the Road