Panasonic AW-RP305 Service Manual

Also see for AWRP301 - PAN/TILT CONTROL PAN: Operating instructions Operating instructions

Contents

Panasonic AW-RP305 Service Manual Manual pdf 6 page image

41 +5V2 ZOOM3 FOCUS4 TILT5 PAN6 GND7 SPEED8 IRISGround GND123467Ground58Example of auxillarycontrol circuitNote: Make sure that the lens and pan/tilt head stopat the center point of the zoom, focus, pan and tilt controls(or at the lever reset position if the controls have a lever reset function).Iris controlZoomcontrol PancontrolTiltcontrolFocuscontrolSPEED switch100Ω 10KΩ10KΩ10KΩ10KΩ6.8KΩ20KΩ6.8KΩ100Ω100Ω100Ω8-pin DIN connectorpin assignment(as viewed from therear of the control panel)@5 Pan/tilt Control Output Connector[TO MULTI PORT HUB, PAN/TILT CONTROL OUT] (RJ-45 8-pin Modular Jack)Connect it to pan/tilt control input connector [PAN/TILT CONTROL IN] on the pan/tilt head with a 10BASE-T straight cable (UTPcategory 5 or equivalent), which may be extended up to 500 meters.S P E E D . S WC H A N G EL O W H I G HZ O O MR E V E R S EN O R R E VZ O O M / F O C U SE X C H A N G EO F F O NF O C U SR E V E R S EN O R R E VT I LTR E V E R S EN O R R E VPA NR E V E R S EN O R R E V Front Panel@6 Speed Switch Changing Switch[SPEED SW CHANGE, LOW/HIGH]Changes the polarity of SPEED Switch !1. If ZOOMlever !8, FOCUS Lever !9, or PAN/TILT Lever @0 ismoved while keeping SPEED Switch !1 depressed, thecorresponding operation takes place at low speed, pro-vided that SPEED SW CHANGE Switch @6 is in theLOW position. If one of these levers is moved withSPEED Switch !1 depressed when SPEED SWCHANGE Switch @6 is in the HIGH position, the corre-sponding operation takes place at high speed.The speed polarity can also be changed by pressingMEMORY Switch o while keeping SPEED Switch !1depressed. When this step is taken again, the originalspeed polarity is restored. Take this step if it is difficultto shift SPEED SW CHANGE Switch @6 because thiscontrol panel is mounted on a console or the like.@7Zoom Reverse Switch[ZOOM REVERSE, NORM/REV]Changes the operating direction of ZOOM Lever !8. Thelens zoom moves toward TELE when ZOOM Lever !8is moved toward TELE, or toward WIDE when it ismoved toward WIDE, provided that ZOOM REVERSESwitch @7 is in the NOR position. When ZOOMREVERSE Switch @7 is set to the REV position, lenszoom operation takes place in the opposite direction.With ZOOM REVERSE Switch @7 in the REV position,the operating directions shown on the panel arereversed. In this case, paste the supplied seal on thepanel.@8 Zoom/Focus Exchange Switch(ZOOM/FOCUS EXCHANGE, ON/OFF]ZOOM Lever !8 and FOCUS Lever !9 exchange theirfunction between them when this switch is set to the ONposition. Unless this exchange is needed, keep theswitch in the OFF position.With ZOOM/FOCUS EXCHANGE Switch @8 in the ONposition, the operations shown on the panel do notagree with the indications on the panel. In this case,paste the supplied seal on the panel.