866-9 Restoring ClipsRestores clips that are defective as a result of sudden powering-down during recording, or removal of the P2 card beingaccessed.Only those clips with yellow corrupt clip markers can berestored. Delete the clips with red corrupt clip markers. If the clipcannot be deleted, format the P2 card.During restoration of the clips, however, the defective-clipindicator may change from yellow to red, resulting in inability torestore the clips.1 Press the THUMBNAIL button.The thumbnail screen appears on the LCD monitor.2 Use the cursor buttons to move the pointer over the clip youwant to restore (defective clips are indicated by corrupt clipmarks).Press the SET button to select the clip.3 Press the MENU BAR button, and select OPERATION REPAIR CLIP from the menu bar.4 The confirmation window appears. Use the cursor buttonsand the SET button to select YES.6-10 Reconnection of incompleteclipsIncomplete clips may be generated when clips recorded onmultiple P2 cards (connected clips) are separately copied todifferent cards. Reconnection function generates one clip (theoriginal, connected clip) from incomplete clips.1 Press the THUMBNAIL button.The thumbnail screen appears on the LCD monitor.2 Use the cursor and SET button to select incomplete clips toreconnect.Usually, thumbnails of incomplete clips (clips withmarker) are displayed in line.3 Press the MENU BAR button and select OPERATION RE-CONNECTION from the menu bar.4 The confirmation window appears. Use the cursor buttonsand SET button to select YES.indication stays illuminated until all the incomplete clips thatcomprise the original clip are reconnected.6-11 Copying clipsSelected clips can be copied to the P2 card or SD memory cardin the desired slot.1 Press the THUMBNAIL button.The thumbnail screen appears on the LCD monitor.2 Use the cursor buttons to move the pointer to the desiredclip and press the SET button.3 Press the MENU BAR button and select OPERATION COPY from the menu bar.Select Slot 1-5 or SD memory card as the destination.4 The confirmation window appears. Use the cursor buttonsand SET button to select YES.ᤨࠫ
