– 166 –Chapter 9 Network Connection — Network settingst All of the IP address, subnet mask, and default gateway must be correctly set.If a warning [CANNOT ACCESS GATEWAY!] appears at the termination of the setting screen, contact the administrator of the network you use.t If you do not use default gateway and DNS, set them to [0.0.0.0].t DHCP and DNS may not function properly depending on the network environment.P2 browser function settings and connection status checkP2 browser function settings1 Configure the settings in the main menu → [NETWORK SETUP] → [NETWORK FUNC] → [HTTP SERVER].[BROWSE]: Enables the P2 browser function.[BROWSE (+CTRL)]: Enables the HTTP server function, starting and stopping recording at the terminal side, and preset control of time code or userbits.[DISABLE]: Disables the HTTP server function.Network operation status display (mode check function)Push the switch on the camera towards the side twice to check the network operation status in the mode check[FUNCTION] screen.For details, refer to “[FUNCTION] screen” (page 146).FTP client function settingBy connecting the camera to network using wireless LAN (wireless access point connection) or wired LAN, you can transfer clips to a server device onthe network.Client settingsTo transfer clips with the FTP client function, you need to set the connection destination and other settings in advance.1 Set each item in the main menu → [NETWORK SETUP] → [CLIENT SERVICE].[FTP SERVER URL]: Sets the name or address of the server to connect to. (Up to 500 characters)[LOGIN USER]: Sets the user ID to connect to. (Up to 31 characters)[LOGIN PASSWORD]: Sets the password to connect to. (Up to 15 characters) The set password cannot be displayed on the unit.[SSH]: Sets when transferring files using SSH.f [ENABLE]: Uses SSH.f [DISABLE]: Does not use SSH.@@ NOTEt The FTP client function does not function when [WLAN] is set in the main menu → [NETWORK SETUP] → [NETWORK SEL], and [DIRECT] is set inthe main menu → [NETWORK SETUP] → [WIRELESS PROPERTY] → [TYPE].Operation check tools, status indication, and initializationYou can check FTP client network connection status as follows.r Checking connection (PING)1 Press the button.The thumbnail screen is displayed.2 Select [PING] in the main menu → [NETWORK SETUP] → [NETWORK TOOL].3 Press the control stick.4 Perform status check of the connection with the address that has been set.When a connection is confirmed, [PING SUCCESSFUL!] appears.If a connection cannot be established within approximately 30 seconds, [PING FAILED!] appears. The log may indicate the cause of a failure.r Displaying the connection log (LOG)1 Select [LOG DISPLAY] in the main menu → [NETWORK SETUP] → [NETWORK TOOL].2 Press the control stick.The log appears.3 After checking the log, press the button.The setting menu screen returns.@@ NOTEt Some operations may not generate any information in the log.t The password is indicated as [*] in the log.r Displaying the status1 Select [STATUS DISPLAY] in the main menu → [NETWORK SETUP] → [NETWORK TOOL].
