– 16 –Chapter 2 Description of Parts — Left sideLeft side123456 87 9 11 13 1420 2115252426 2728293031222310 1216 1817 191 Focus ring (page 46)Focus manually when the switch is set to .2 Zoom ring (page 53)Adjust the zoom manually when the switch is set to .3 Lens cover switching lever (page 29)Open/close the lens cover.4 Iris ring (page 46)Adjust the lens iris manually when the manual iris is set with the button.5 switch (page 53)Select the operation of the zoom.: You can use the motor-driven zoom using the zoom lever.: You can operate the zoom ring manually to adjust the angle of view.6 switch (page 71)This is the spring switch to check the status of the shooting, etc.f Push this switch towards the side to clear all displays except the display of the operation status, frame display such as an area, counter,marker, and safety zone.f Push this switch towards the side to display all information such as setting status of the functions for the shooting, the list of functionsassigned to the USER buttons on the LCD monitor during shooting stand-by or shooting. Each time the switch is pushed towards the side,the display of the status switches in turn.7 switch (page 46)Switch the brightness of the screen according to the lighting conditions under which you are shooting.8 dial (page 63)In the following conditions, the recording levels for the audio channels 1 to 4 can be adjusted.f When the / switch is set to f When [AUTO LEVEL CH3]/[AUTO LEVEL CH4] is set to [OFF] in the main menu → [AUDIO SETUP] → [RECORDING CH SETTING]Assignment of audio channels 1 to 4 can be performed in the main menu → [AUDIO SETUP] → [RECORDING CH SETTING] → [FRONT VRSELECT].9 switch (page 50)Select the method for adjustment of the white balance.: Set the white balance to the preset value. Each time the button is pressed, [3200K], [5600K], and [VAR] are toggled./: Select when using the stored value of the adjustment of the white balance.10 115)Press this button to display [USER MENU]. Press this button for 3 seconds or more to display the main menu. Press it again to return to the originalimage.11 dial button (page 115)Move, select, and set the items in the setting menu while the setting menu is displayed.Set the preset values of the shutter, synchro scan, variable frame rate value, and white balance.12 button (page 58)f When the setting menu is not displayed, each press of the button switches modes to change the variable value of shutter speed, variable framerate, and white balance.f When the setting menu is displayed, setting of the menu items is canceled and the previous screen is displayed. |
