– 164 –Chapter 9 Network Connection — Network settingsEnter a password of the wireless access point for destination in [ENCRYPT KEY] of the of the camera.f Factory setting: [01234567890123456789abcdef]5 Check the network connection.When the setting is completed, confirm that network connection between the camera and the wireless access point is made properly.When network connection is made properly, the network status icon at the upper right of the thumbnail screen changes in yellow, and applications(P2 Browser, FTP client function) which require network can be used.@@ NOTEt There are following restrictions while wireless LAN is set.- Regardless of menu settings, signals are not output from the terminal.- The LCD monitor and viewfinder cannot be used together. The LCD monitor is not displayed while the viewfinder is used.Starting application (P2 Browser) from web browserAfter completing the network connection with your mobile device or computer, start the browser of the mobile device or computer, and then start theapplication (P2 Browser).Fig. 11 Select [BROWSE] or [BROWSE (+CTRL)] in the main menu → [NETWORK SETUP] → [NETWORK FUNC] → [HTTP SERVER].P2 browser function is enabled.2 Start the browser of your mobile device or computer (Safari, Internet Explorer).3 Enter the IP address set for the camera in the address entry field of the browser.f Factory setting: [192.168.0.1]4 If you use a computer, press the Enter key, and if you use iPad/iPhone, tap the GO button.The web application (P2 Browser) starts up.5 Enter [USER NAME] and [PASSWORD] on the entry screen.Enter [USER ACCOUNT] (Factory setting: [guest]) and [PASSWORD] (Factory setting: [p2guest]) that have been set for the camera.When a screen like (Fig. 1) appears (for iPad), the connection has been established.User account name and password can be set in the main menu → [NETWORK SETUP] → [NETWORK FUNC] → [USER ACCOUNT].Accounts can be created or deleted, and the passwords can be changed in the main menu → [NETWORK SETUP] → [NETWORK FUNC] →[ACCOUNT LIST].For details on P2 Browser, refer to the following website.http://pro-av.panasonic.net/Wired LAN settingsThe settings to connect to computers using the wired LAN are as follows.1 Set each item in the main menu → [NETWORK SETUP] → [LAN PROPERTY] as necessary.[DHCP] and [DHCP SERVER] are mutually exclusive.[MAC ADDRESS]: MAC address of wired LAN (cannot be changed)[DHCP]: Setting whether to use automatic acquisition via DHCP ([ENABLE]: Use automatic acquisition/[DISABLE]: Does not use automaticacquisition (Factory setting: [ENABLE])[IP ADDRESS]: IP address (Factory setting: [192.168.0.1])[SUBNET MASK]: Subnet mask (Factory setting: [255.255.255.0])[DEFAULT GATEWAY]: Default gateway (Factory setting: [192.168.0.254])[PRIMARY DNS]: Primary DNS server setting (Factory setting: [0.0.0.0])[SECONDARY DNS]: Secondary DNS server setting (Factory setting: [0.0.0.0])[DHCP SERVER]: Setting whether to use the DHCP SERVER function ([ENABLE]: Uses the DHCP SERVER function/[DISABLE]: Does not usethe DHCP SERVER function) (Factory setting: [DISABLE])2 Select [LAN] in the main menu → [NETWORK SETUP] → [NETWORK SEL].
