Block 3The counter values are displayed in units of hours,minutes, seconds and frames.Block 4 (when T&STA is set for the set-up menu itemNo. 000)EJECT E_PLAYSTOP SHTLREW JOGFF VARSTOP PPLYSTANDBY_OFF POWER OFFPLAY AUTO OFFREC DEWEDIT• Search speed display• REV, SHTL and FWD are displayed during externalVTR control.• In the jog mode, REV, STILL or FWD is displayed.• The tape speed is displayed in SHTL, VAR andPPLY.SHTL – 32.0 (where “32.0” is the speed and “–”denotes the reverse tape direction (compared with“+” which denotes the forward tape direction)Block 4 (when T&YMD, T&MDY, T&DMY or T&RT is setfor the set-up menu item No. 000)DATE: Date on which tape was shotD*TE: Date on which tape was shot (when it cannot beread)TIME: Time (hr/min/sec) at which tape was shotT*ME: Time at which tape was shot (when it cannot beread)Superimposed displays can be added to the laptop’s liquid-crystal TV monitor or to the signals output from the VIDEO MONI-TOR connector.With the on-screen display, the superimposed signals are added to the liquid-crystal TV monitor or to the signals output from theVIDEO MONITOR connector.To superimpose displays:First check the connections, and then press the COUNTER/REMAIN switch. Check that characters are now displayed on themonitor.If no characters are superimposed, press the COUNTER/REMAIN switch again.For details on the superimposed display function, refer to the next page.SUPERIMPOSE SCREEN DISPLAYS66TCRSHTL + 32.012 : 34 : 43 : 21Block 1 Block 2 Block 3Block 412 : 34 : 43 : 21: Non-drop frame mode. Drop frame mode: Normal mode. Time track modeBlock 1CTL : Control signalTCR : Time codeT*R : Time code (when it cannot be read)UBR : User bitU*R : User bit (when it cannot be read)TCG : Time code generator valueUBG : User bit generator valueBlock 2No display : Normally, nothing is displayed here.P : When the supply voltage has droppedS : When the fan has stoppedL : When LOW RF