The video IN point can be offset from the audio IN point during insert editing.! Set AUDIO for the set-up menu item No.311 (SPLIT EDIT).@ Select the insert editing channel.# Enter the audio edit IN points of the player and recorder.$ Press the SPLIT button.Check that the SPLIT button lamp has lighted.The IN lamps on the player and recorder flash.% Search the player’s video IN point, and press the player’s IN button while holding down the ENTRY button. When the INpoint is entered, the IN lamp lights.^ Press the SPLIT button.The SPLIT button lamp changes from the lighted to a flashing status.& Enter the OUT point of the player or recorder.* Press the PREVIEW button to conduct a preview.( Press the AUTO EDIT button.Correcting an edit IN pointCheck that the SPLIT button lamp is lighted, and repeat steps $ and %.Displaying the video split amountPress the IN and OUT buttons at the same time while the SPLIT lamp is flashing.The difference between the video split IN point and audio IN point is displayed on the time counter.The video split IN point and audio OUT point cannot be corrected at the same time by pressing the + or – button while theSPLIT button lamp is lighted.• The video split IN point is entered while the SPLIT button lamp is flashing.• Check that AUDIO is set for the set-up menu item No.311 (SPLIT EDIT).--- ----------------------EJECTV T R 1POWERRECCH1 RESETRECDIAGREMOTEEXT VTRLOCAL-VTR1 VTR2CONTROLONOFFRECINHIBITOFF ONCH2PBAUDIO LEVELREW FFSTOP STB OFF TRACKPLAY STILL1ST EDITBSEVENTSPLITASMBLIN OUTVTR1 VTR2 VTR1 VTR2PREROLLSYNCHRO753CFONOFFCH1MIXCH2V1V1•2V2SWAPNORMMIXAUDIOMONITOR SPEAKER/HEADPHONES AUDIOSWAPDUMP LOAD EDLCLEARFSRECALLLASTEDITV A1 A2 TCPLAYIN OUTGO TOENTRY / SHIFTEDIT MODECOUNTERCTLTCUBVTR1EJECTV T R 2RESETRECSTORESTOP STB OFFMENUEDITSTILL REW FFVTR2RECCH1 CH2OPERATION MODE VTR2 AUDIOINPUT SELECTEDITINTEXTSEPARATE CH1 CH2VTR1EXTPBAUDIO LEVELPREVIEWREVIEW MULTIAUTO EDIT ALL STOPVIDEO SPLIT EDITING PROCEDURE46