AUDIO SPLIT EDITING PROCEDURE45In the insert edit mode, the audio IN point can be offset from the video IN point for editing.! Set VIDEO for the set-up menu item No.311 (SPLIT EDIT).@ Select the channel for insert editing.# Register the video edit IN points of the player and recorder.$ Press the SPLIT button. Check that its lamp has lighted. The IN lamps on the time counters of the player and recorder flash.% Search the player’s audio IN point, and press the player’s IN button while holding down the ENTRY button.Once the IN point has been registered, the IN lamp has lighted.^ Press the SPLIT button. The SPLIT lamp flashes.& Register the OUT point of the player or recorder.* Press the PREVIEW button to preview the points.( Press the AUTO EDIT button.Revising an edit IN pointCheck that the SPLIT lamp has lighted, and repeat steps 4 and 5.Displaying the audio split amountPress the IN and OUT buttons together while the SPLIT lamp flashes. The difference between the audio split IN point and videoIN point is displayed on the time counter.While the SPLIT lamp is lighted, the audio split IN and video OUT points cannot be revised simultaneously by pressing the “+” or“–” button.• If the SPLIT lamp flashes, it means that the audio split IN point has been registered.• Check that VIDEO has been set for the set-up menu item No.311 (SPLIT EDIT).--- ----------------------EJECTV T R 1POWERRECCH1 RESETRECDIAGREMOTEEXT VTRLOCAL-VTR1 VTR2CONTROLONOFFRECINHIBITOFF ONCH2PBAUDIO LEVELREW FFSTOP STB OFF TRACKPLAY STILL1ST EDITBSEVENTSPLITASMBLIN OUTVTR1 VTR2 VTR1 VTR2PREROLLSYNCHRO753CFONOFFCH1MIXCH2V1V1•2V2SWAPNORMMIXAUDIOMONITOR SPEAKER/HEADPHONES AUDIOSWAPDUMP LOAD EDLCLEARFSRECALLLASTEDITV A1 A2 TCPLAYIN OUTGO TOENTRY / SHIFTEDIT MODECOUNTERCTLTCUBVTR1EJECTV T R 2RESETRECSTORESTOP STB OFFMENUEDITSTILL REW FFVTR2RECCH1 CH2OPERATION MODE VTR2 AUDIOINPUT SELECTEDITINTEXTSEPARATE CH1 CH2VTR1EXTPBAUDIO LEVELPREVIEWREVIEW MULTIAUTO EDIT ALL STOPAudio split editing procedure