NEC PX-42XM4A User Manual

Also see for 50XM5A: Supplementary guide Specifications Installation guide

Contents

NEC PX-42XM4A User Manual Manual pdf 15 page image

En-14FULL size screenThe image is expanded in the horizontal and verticaldirection.ZOOM size screenWhen wide signals are input.TRUEThe image is true resolution.FULLInformation Supported resolutionSee page En-40 for details on the display output of thevarious VESA signal standards supported by themonitor. “PICTURE SIZE” settingWhen the setting of “PICTURE SIZE” is OFF, the sizeof RGB-input pictures will be TRUE in place ofNORMAL. When 852 (848) dot 480 line wide VGA*signals with a vertical frequency of 60 Hz andhorizontal frequency of 31.7 (31.0) kHz are in-putSelect an appropriate setting for RGB SELECT modereferring to the“Table of Signals Supported” on pageEn-40.* “VGA”, “SVGA” and “SXGA” are registeredtrademarks of IBM, Inc. of the United States.Note:Do not allow 4:3 content to be displayed for extendedperiods of time without using gray bars. This can causeimage retention.Wide Screen Operation withComputer SignalsSwitch to the wide screen mode to expand the 4 : 3 imageto fill the entire screen.1. Press the WIDE button on the remote control.2. Within 3 seconds ...Press the WIDE button again.The screen size switches as follows:→ NORMAL → FULL → ZOOMWhen displaying enhanced split screen:NORMAL ↔ FULLNORMAL size screen (4:3 or SXGA 5:4)The picture has the same size as the normal computer image.FULL size screenThe image is expanded in the horizontal direction.ZOOM size screenWhen wide signals are input.FULL size screenWhen “PICTURE SIZE” is set to “OFF”* This cannot be set in some models. “TRUE” size will notbe displayed in such cases.The screen size switches as follows:→ TRUE → FULL → ZOOMTRUE size screen (VGA, SVGA 4:3)The image is true resolution.