NEC NP901W User Manual

Also see for NP901W: Control commands Specifications Quick setup guide Installation guide Network Setup

Contents

NEC NP901W User Manual Manual pdf 129 page image

1156. Using On-Screen Menu[OPTIONS]Setting Auto Adjust [AUTO ADJUST]This feature sets the Auto Adjust mode so that the RGB image can be automatically or manually adjusted for noiseand stability. You can automatically make adjustment in two ways: [NORMAL] and [FINE].OFF......................... The.RGB.image.will.not.be.automatically.adjusted.You.can.manually.optimize.the.RGB.image.NORMAL................. Default.setting..The.RGB.image.will.be.automatically.adjusted..Normally.select.this.option.FINE........................ Select. this. option. if. fine. adjustment. is. needed.. It. takes. more. time. to. switch. to. the. source. than. when.[NORMAL].is.selected.Enabling Auto Power On [AUTO POWER ON (AC)]Turns the projector on automatically when the power cable is inserted into an active power outlet and the main pow-er switch is turned on. This eliminates the need to always use the POWER button on the remote control or projectorcabinet.To use the AUTO POWER ON (AC) function, you must first press the main power switch to the position “On” beforeplugging in the power cable.Enabling Power Management [AUTO POWER OFF]When this option is selected you can enable the projector to automatically turn off (at the selected time: 5min.,10min., 20min., 30min.) if there is no signal received by any input.Enabling High Speed Fan Mode [FAN MODE]This option allows you to select three modes for fan speed: Auto mode, High speed mode, and High Altitude mode.AUTO...................... The.built-in.fans.automatically.run.at.a.variable.speed.according.to.the.internal.temperature.HIGH....................... The.built-in.fans.run.at.high.speed.HIGH.ALTITUDE...... The.built-in.fans.run.at.a.high.speed..Select.this.option.when.using.the.projector.at.altitudes.approximate-ly.5500.feet/1600.meters.or.higher.When you wish to cool down the temperature inside the projector quickly, select [HIGH].NOTE:• It is recommended that you select High speed mode if you use the projector non-stop for consecutive days.• Using the projector at altitudes approximately 5500 feet/1600 meters or higher without setting to [HIGH ALTITUDE] can causethe projector to overheat and the protector could shut down. If this happens, wait a couple minutes and turn on the projector.• Using the projector at altitudes less than approximately 5500 feet/1600 meters and setting to [HIGH ALTITUDE] can cause thelamp to overcool, causing the image to flicker. Switch [FAN MODE] to [AUTO].• Your setting will not be affected even when [RESET] is done from the menu.