NEC NP610 User Manual

Also see for NP305: User manual Quick setup guide Specification Quick setup guide Quick setup guide quick setup guide

Contents

NEC NP610 User Manual Manual pdf 7 page image

ivImportant Information• Handle the power cable carefully. A damaged or frayed power cable can cause electric shock or fire.- Do not use any power cables than the supplied one.- Do not bend or tug the power cable excessively.- Do not place the power cable under the projector, or any heavy object.- Do not cover the power cable with other soft materials such as rugs.- Do not heat the power cable.- Do not handle the power plug with wet hands.• Turn off the projector, unplug the power cable and have the projector serviced by a qualified service personnel underthe following conditions:- When the power cable or plug is damaged or frayed.- If liquid has been spilled into the projector, or if it has been exposed to rain or water.- If the projector does not operate normally when you follow the instructions described in this user’s manual.- If the projector has been dropped or the cabinet has been damaged.- If the projector exhibits a distinct change in performance, indicating a need for service.• Disconnect the power cable and any other cables before carrying the projector.• Turn off the projector and unplug the power cable before cleaning the cabinet or replacing the lamp.• Turn off the projector and unplug the power cable if the projector is not to be used for an extended period of time.• When using a LAN cable (only models with the RJ-45 LAN port):For safety, do not connect to the connector for peripheral device wiring that might have excessive voltage.CAUTION• Do not use the tilt-foot for purposes other than originally intended. Misuses such as gripping the tilt-foot or hang-ing on the wall can cause damage to the projector.• Do not send the projector in the soft case by parcel delivery service or cargo shipment. The projector inside thesoft case could be damaged.• Select [HIGH] in Fan mode if you continue to use the projector for consecutive days. (From the menu, select[SETUP] → [OPTIONS(1)] → [FAN MODE] → [HIGH].)• Do not try to touch the ventilation outlet on the left front (when seen from the front) as it can become heated whilethe projector is turned on and immediately after the projector is turned off.• Do not turn off the AC power for 60 seconds after the lamp is turned on and while the POWER indicator is blink-ing green. Doing so could cause premature lamp failure.Remote Control Precautions• Handle the remote control carefully.• If the remote control gets wet, wipe it dry immediately.• Avoid excessive heat and humidity.• Do not heat, take apart, or throw batteries into fire.• If you will not be using the remote control for a long time, remove the batteries.• Ensure that you have the batteries’ polarity (+/−) aligned correctly.• Do not use new and old batteries together, or use different types of batteries together.• Dispose of used batteries according to your local regulations.