987. AppendixNOTE: Contact your local dealer for a full list of the PC Control Codes if needed.Cable ConnectionCommunication ProtocolBaud rate .........................................19200 bpsData length ......................................8 bitsParity ...............................................No parityStop bit ............................................One bitX on/off ............................................NoneCommunications procedure.............Full duplexNOTE: Depending on the equipment, a lower baud rate may be recommended for long cable runs.PC Control Connector (D-SUB 9P) PC Control Codes and Cable ConnectionPC Control CodesFunction Code DataPOWER ON 02H 00H 00H 00H 00H 02HPOWER OFF 02H 01H 00H 00H 00H 03HINPUT SELECT COMPUTER 1 02H 03H 00H 00H 02H 01H 01H 09HINPUT SELECT COMPUTER 2 (Digital) 02H 03H 00H 00H 02H 01H 1AH 22HINPUT SELECT COMPUTER 2 (Analog) 02H 03H 00H 00H 02H 01H 02H 0AHINPUT SELECT VIDEO 02H 03H 00H 00H 02H 01H 06H 0EHINPUT SELECT S-VIDEO 02H 03H 00H 00H 02H 01H 0BH 13HPICTURE MUTE ON 02H 10H 00H 00H 00H 12HPICTURE MUTE OFF 02H 11H 00H 00H 00H 13HSOUND MUTE ON 02H 12H 00H 00H 00H 14HSOUND MUTE OFF 02H 13H 00H 00H 00H 15HNOTE 1: Pins 1, 4, 6 and 9 are no used.NOTE 2: Jumper “Request to Send” and “Clear to Send” together on both ends of the cable to simplify cable connection.NOTE 3: For long cable runs it is recommended to set communication speed within projector menus to 9600 bps.1 52 436 7 98To GND of PCTo RxD of PCTo TxD of PCTo RTS of PCTo CTS of PC
