NEC NP610 User Manual

Also see for NP305: User manual Quick setup guide Specification Quick setup guide Quick setup guide quick setup guide

Contents

NEC NP610 User Manual Manual pdf 38 page image

283. Projecting an Image (Basic Operation)Note on Startup screen (Menu Language Select screen)When you first turn on the projector, you will get the Startup menu. This menu gives you the opportunity to select oneof the 21 menu languages.To select a menu language, follow these steps:1. Use the , ,  or  button to select one of the 21languages from the menu.2. Press the ENTER button to execute the selection.After this has been done, you can proceed to the menuoperation.If you want, you can select the menu language later.(→ [LANGUAGE] on page 58 and 70)NOTE: Immediately after turning on the projector, screen flicker may occur. This is normal. Wait 3 to 5 minutes until the lamp light-ing is stabilized.NOTE: If you turn on the projector immediately after the lamp is turned off, the fans run without displaying an image for some timeand then the projector will display the image.CAUTION:The projector cannot be turned off for 60 seconds after the lamp is turned on and while the POWER indicator is blinkinggreen. Doing so could cause premature lamp failure.When the [ECO MODE] is set to [ON], the LAMP indicator will light green.If one of the following things happens, the projector will not turn on.• If the internal temperature of the projector is too high, the projector detects abnormal high temperature. In thiscondition the projector will not turn on to protect the internal system. If this happens, wait for the projector’s internalcomponents to cool down.• When the lamp reaches its end of usable life, the projector will not turn on. If this happens, replace the lamp.• If the lamp fails to light, and if the STATUS indicator flashes on and off in a cycle of six times, wait a full minute andthen turn on the power.NOTE: Turning the Main Power Switch Off then Back OnAllow a minimum of 1 second between turning off the main power switch and turning it back on again.The same will be applied when a power strip equipped with a switch and a breaker is used.Failing to do so could result in no power to the projector. (There will be no stand-by LED)Should this happen, unplug the power cable and plug it in again. Turn on the main power switch.ENTER EXITMENUUPMAGNIFY PAGEOFFPOWERONAV-MUTEDOWNENTER EXITMENUUPMAGNIFY PAGEOFFPOWERONAV-MUTEDOWNMENUEXITENTERMENUEXITENTER