NEC NP610 User Manual

Also see for NP305: User manual Quick setup guide Specification Quick setup guide Quick setup guide quick setup guide

Contents

NEC NP610 User Manual Manual pdf 51 page image

414. Convenient Features Changing Eco ModeThis feature enables you to select two brightness modes of the lamp:OFF and ON modes. The lamp life can be extended by turning on the [ECO MODE].[ECO MODE] Description Status of LAMP indicator[OFF] This is the default setting (100% Brightness). OffSTATUSLAMP[ON] Select this mode to increase the lamp life (approx.70% Brightness on NP610/NP510W/NP410W/NP610S/NP510WS and approx. 80% Brightness onNP510/NP410/NP405/NP310/NP305).Steady Green lightSTATUSLAMPTo turn on the [ECO MODE], do the following:1. Press the ECO MODE button on the remote control to display [ECO MODE] screen.2. Use the  or  button to select [ON].3. Press the ENTER button.To change from [ON] to [OFF], Go back to Step 2 and select [OFF]. Repeat Step 3.NOTE:• The [ECO MODE] can be changed by using the menu.Select [SETUP] → [GENERAL] → [ECO MODE].• The lamp life remaining and lamp hours used can be checked in [USAGE TIME]. Select [INFO.] →[USAGE TIME].• The projector is always in [ON] for 90 seconds after the lamp is turned on and while the POWER indicator is blinking green. Thelamp condition will not be affected even when [ECO MODE] is changed.• After a lapse of 1 minute from when the projector displays a blue, black or logo screen, [ECO MODE] will automatically switch to[ON]. The projector will return to the [OFF] once a signal is accepted.• If the projector is overheated in [OFF] mode, there may be a case where the [ECO MODE] automatically changes to [ON] modeto protect the projector. When the projector is in [ON] mode, the picture brightness decreases. When the projector comes backto normal temperature, the [ECO MODE] returns to [OFF] mode.Thermometer symbol [ ] indicates the [ECO MODE] is automatically set to [ON] mode because the internal temperature is toohigh.2. Press the  button.The area of the magnified image will be moved3. Press the MAGNIFY (−) button.Each time the MAGNIFY (−) button is pressed, the image is re-duced.NOTE:• The image will be enlarged or reduced at the center of the screen.• Displaying the menu will cancel the current magnification. ENTER EXITMENUUPMAGNIFY PAGEOFFPOWERONAV-MUTEDOWN